I do hope you can help, I have a Sirrus TS1503 shower connected to a combi boiler. Sometimes, not all the time, the shower will be cold to start with and stays that way. if you leave a while and then try again it will be OK warm/hot does not get cold when in use, and temperature is very controllable. Do you think this is a cartridge problem, or do you think servicing the cartridge would cure this startup problem. The reason I ask is cos when working all control of temp etc. is all ok. Your help would be genuinely appreciated
Discuss Sirrus TS1503 cold on start in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net
SimonG,
thanks for your reply, when you say clean filters do you mean the hot and cold feed filters. Should I remove the whole controller and clean inside the cartridge as well. Please excuse my inappropriate use or the terms, but your advice is appreciated
Reply to Sirrus TS1503 cold on start in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net
Similar plumbing topics
I've just replaced an Ultra SASF2 – M thermostatic shower cartridge together with the spring mechanism and the temperature sensor.
My problem is...
Can anyone help
My shower is warm, but when I flush the toilet or leave the cold tap on, if gets
Hotter. The temperature I imagine a shower...
Hello
I need to replace my Grohe Geotherm shower cubicle mounted control unit.
Its around 17 years old but replacements seem to be available
The...
- Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Hello. My mixer shower (non-electric) recently started running luke warm. I know this can happen at this time of year over winter but I've been in...