Discuss Shower goes cold after 5 minutes in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
1
hi everyone

I’m a novice in terms of diy but wonder if you can advise me at all.

I had a new combi boiler fitted in September and everything has been fine until now.

My shower is one that comes off a mixer tap on the bath. For some reason it now goes cold about 5 minutes into a shower.

My hot water comes off the combi and the cold is direct off the mains.

If I don’t put the cold water on at all then the shower runs hot constantly with no problem. If I put the cold on even just a little bit then after the 5 minutes everything goes cold.

If I turn the cold tap off when this has happened then the hot tap continues to run but the water doesn’t come back to hot. I have to turn the hot tap off and back on again to get the hot water back.

I’m not sure why this has started happening now. My cold water has always been high pressure but it hasn’t changed that I can tell.

Any advice of simple things I can try? If I call the boiler people to come out I’m not sure if I’d be covered as the hot water is fine without the cold tap being on so it’s not the boiler that’s at fault (or is it?).

Thanks everyone
 
hi everyone

I’m a novice in terms of diy but wonder if you can advise me at all.

I had a new combi boiler fitted in September and everything has been fine until now.

My shower is one that comes off a mixer tap on the bath. For some reason it now goes cold about 5 minutes into a shower.

My hot water comes off the combi and the cold is direct off the mains.

If I don’t put the cold water on at all then the shower runs hot constantly with no problem. If I put the cold on even just a little bit then after the 5 minutes everything goes cold.

If I turn the cold tap off when this has happened then the hot tap continues to run but the water doesn’t come back to hot. I have to turn the hot tap off and back on again to get the hot water back.

I’m not sure why this has started happening now. My cold water has always been high pressure but it hasn’t changed that I can tell.

Any advice of simple things I can try? If I call the boiler people to come out I’m not sure if I’d be covered as the hot water is fine without the cold tap being on so it’s not the boiler that’s at fault (or is it?).

Thanks everyone

These sort of shower attachments are not the best thing to use a very good risk of being scalded because you cant control the temperature and an imbalance of water pressure, you would be better to install a proper thermostatic controlled one, or an electric shower
 
Status
Not open for further replies.

Reply to Shower goes cold after 5 minutes in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

    • Like
Hoping someone can please help. I have an intermittent fault with my electric hot water. I have an older style electric hot water service that...
Replies
6
Views
505
Hi all Hope you can help We have a Gloworm Ultracom 38CXI combi boiler. During the Summer the taps and mixer shower run hot water consistently...
Replies
0
Views
483
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
278
Hi, I was hoping to get some advice. I live in a three floor house with a gravity fed cold water system for all of the bathrooms. The tank is in...
Replies
3
Views
171
Looking for any ideas to help. I've a Heatrae Sadia Hot Water tank, heated through Oil fired boiler (working fine). A week ago I reset the air...
Replies
8
Views
374
Back
Top