Search the forum,

Discuss Saying hello in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

Last Plumber

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
4,817
Hello, I'm new to the forum and not sure how it works properly yet, !
 
How do those banners appear
I.e. gas safe yellow banner ?
Is there a way of adding them to your profile
 
If you're gas safe you need to make 10 posts and then contact one of the admin who will deal with it
 
mailto:[email protected]

As said 10 non spaming posts - You`ve done this.
Picture of your card sent to the link above along with your forum user name and wait.
 
Welcome to the forum's Last Plumber......regards Turnpin:welcome:
 
Thanks again to all.
The ankle biter has been mentioned twice. Will it bite through my boots or is it not that big a threat ?
I'm sure you'll let me know in due course !
 
welcome along, it's not the ankle biter you need to look out for it's Adam and his dodgy choice of drink lol
 
:welcome:
 
Ankle biters, ginger step daughters, babycham and vimto, secret codes and umberellas.
Really. I only said hello !
 
welcome along, mosy of us are friendly ,beware the bolshy n grumpy mods, especially the lower part of the ankle biter (Ronnie Corbett made him seem tall). If your on holiday, he may look like this in the pool


but don't let him near your facebook page ever![
 

Attachments

  • ********.jpg
    ********.jpg
    10.9 KB · Views: 12
Last edited by a moderator:
I'm picturing you all with straight jackets on, typing with a pencil between your teeth !
 
Need I unleash Mr Weeks photo so everyone can laugh at you on here too?

he is looking at getting wet feet when he hops into his dry suit next time, got to say though my diet hasnt been that successful to get through the gap :) Point made on access to facebook though.....
 
Status
Not open for further replies.

Reply to Saying hello in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
157
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
244
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
153
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
211
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
265
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock