Search the forum,

Removing very informative but annoying message.......

Post new thread

Discuss Removing very informative but annoying message....... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

PowerFlusher2

Job done, but will I have to do this following every 7 days of inactivity on my part?
 
Keeps you active ( but may lower quality of my posts if that's Possible ! )

over a certain number of posts we should get a Nag holiday .

... had me worried something usefull about ,Clearing sludge was for the Chop !
 
Status
Not open for further replies.

Reply to Removing very informative but annoying message....... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
222
SimonG
SimonG
B
    • Friendly
Posting a thread as until now I've only read the forum
Hi, I've followed this excellent forum for several years but have never posted, so decided I'd better give some details. My status is the upper end of DIY and I've a couple of house renovations under my belt (my own homes) I am retired but do volunteer handyman jobs for the elderly. Not...
Replies
2
Views
170
turnpin
turnpin
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
155
Lou
Lou
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
214
Timmy D
T
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
212
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tile News
Tiling Advice
Tiling Advice
Tilers' Talk
Tile Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock