Search the forum,

Pulsar direct TRV pin leaking looking for spares

Post new thread

Discuss Pulsar direct TRV pin leaking looking for spares in the Water Underfloor Heating Advice area at PlumbersForums.net

R

RayPlumb

Messages
181
I have a client with 5 manifolds that are Pulsar Direct supplied .I know Pulsar direct are no longer. I have a few with leaking TRV (RBM -TL50) pins. How easy is it to change the pin side of the valve. . Are they standard or specific to the manifold?
Where would I look for spares. Just had 'we can supply new maifold' so far. Don't want to change the manifold just because of a remote TRV.
Attached some pics . any help appreciated.
Thanks
 

Attachments

  • 20201201_100033.jpg
    20201201_100033.jpg
    383.8 KB · Views: 12
  • 20201123_094540.jpg
    20201123_094540.jpg
    328.1 KB · Views: 13

Reply to Pulsar direct TRV pin leaking looking for spares in the Water Underfloor Heating Advice area at PlumbersForums.net

Similar plumbing topics

C
Y Plan, no hot water but heating is working when called
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
291
John.g
J
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
190
Timmy D
T
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
234
Dave Moore
D
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
dreikher
dreikher
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
130
Lou
Lou
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Plumbers Forum - Plumbing Advice
DIY Forum
Tile Advice
Tile Talk
Tiling Tools
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock