Discuss Mac flash universal lead slate in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Scott_D

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
6,131
Are these good or best avoided?
I need to give a builder a lead slate to put into the roof for a boiler install at a later date.
The mcalpine Mac flash universal slate is very cheap at the merchants.
Are they good or best to stick to the manufacturers own slate kit?
 
TBH I would always go for a manufacturer’s own reason why the flies designed for it eg like the baxi and Worcester ones the flue slots into it
 

Reply to Mac flash universal lead slate in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
259
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended...
Replies
6
Views
320
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new...
Replies
2
Views
279
My son has an apprenticeship interview for to become a plumber and heating engineer. The have said there will be a multiple choice exam for this...
Replies
3
Views
512
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my...
Replies
3
Views
598
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock