Search the forum,

Looking for a unpaid work trainee placement for a few days a week.

Post new thread

Discuss Looking for a unpaid work trainee placement for a few days a week. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
L

Lewis7

Hi

I am currently doing my level 2 city & guilds plumbing and domestic heating.
I am badly in need of some experience as the class room only deals with a small part.

I'm a hard worker and am willing to work for free as i know it is tough times for plumbers, it will also only be a few days a week as i am at college on 2 days of the week.

If anyone if east or north London can help please.

Thanks

Lewis
 
Status
Not open for further replies.

Reply to Looking for a unpaid work trainee placement for a few days a week. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
316
Chuck
C
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
405
FozzieBear
F
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
475
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
182
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock