Discuss kinked, crimped and coiled 8mm pipework in the Plumbing Jobs | The Job-board area at PlumbersForums.net
I see what you mean, I've tried 3 so far, 3200, 4200 & 3700btu!
So him crimping a bypass pipe constitutes an auto bypass or have I had bodge it n scarper fit this system?
I haven't discovered one yet. Where's the most likely place for one?
Unless it's mid run on the 8mm then there isn't one, I'll just fit two lockshields on a rad . I'm sure the pre prepped unvented will have one, won't it?
One other question... Fitting a new 22mm pipe, hole in the beam or notches in the top? Which is most viable and professional?
Is it worth running 22mm to the bath hot tap from an unvented? Or is this overkill?
Is it worth running 22mm to the bath hot tap from an unvented? Or is this overkill?
Aren`t bath taps 22mm rather than 15mm?
Aren`t bath taps 22mm rather than 15mm?
No idea, my last lot of surface mounted taps and overflow filler were 15mm...
Reply to kinked, crimped and coiled 8mm pipework in the Plumbing Jobs | The Job-board area at PlumbersForums.net
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.