Discuss Industrial showers? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
T

truemanufan

Anyone do any work on industrial side? If so I have had a call with regards to installing some showers in an industrial property. I have never done this before, it seems like a specialist area to me, just want to know if there in any specific legislation towards this or would it all be covered in water regs? Thanks
 
It will mainly come down to the scale of the works but paying careful prevention to legionella prevention measures. A lot of group showering solutions will share the mixing valve over several showers so you need to be careful over distances. I once shut down an entire sports centre because an incorrectly installed group showering valve had allowed the cold water storage cistern to heat to 37 degrees. The centre was shut for 2 days whilst I rectified the plumbing and disinfected the whole system.
 
Fortunately they were happy to follow my advice as I advised them of the potential dangers. It was actually owned by a church who used it for worship on Sundays and as a sports centre/conference centre in the week.

I also closed the place down at a later date as well. I walked into the place first thing one morning and it reeked of gas. I opened all the doors and evacuated the staff. I went to the meter room to shut off the gas and as I opened the door it stank. I shut off the gate valve on the 6" incoming main and could see that the cover over the dials on the meter looked distorted. I sprayed around it with leak detection fluid and it was bubbling like mad. I rang Transco and the chap arrived about twenty minutes later, took one look at the meter and rang his boss. The meter was about 4 foot cubed. The commercial guys turned up about two hours later, looked at the meter, agreed with my diagnosis and then the fun started. The only replacement meter in the country was in Scotland and it took until the following morning to get it to site. I then had to get a commercial guy in to re commission all of the radiant tube heaters.

I've got a good track record of shutting places down.
 
Status
Not open for further replies.

Reply to Industrial showers? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
220
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
Replies
1
Views
271
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Replies
6
Views
288
Hello I am looking to install a slimline dishwasher (integrated) into a cupboard in my kitchen. The depth of the dishwasher is 550mm and the...
Replies
22
Views
599
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is...
Replies
5
Views
555

Newest Plumbing Threads

Back
Top