Ideal Elan replacement

[king of pipes]

Called out to a breakdown on one of these today stripped down only to find the flue rotted out so condemned it , now the tricky bit the boiler is under the stairs fitted low down open vent on a y plan hotwater cylinder right next to it all controls there to , boiler position and flue is causing me concern as it's near the neighbours boundary although they have had a boiler replaced 2 years please see attached i have had issues with plumeing over a boundry before and had to have a meeting with gasafe to resolve the issue which was acceptable in the end so dont want to go risk that happening again boiler needs replacing asap no other possible position without major upheaval any opions chaps ? Cheers kop

 

[Harvest Fields]

What boiler you looking at fitting mate. That looks like enough clearance to be honest. Can you not angle a plume kit to give you more distance?

 

[quality]

job i was on this week was similar both with plume kits 180 degree to each other

 

[Last Plumber]

any opions chaps ?

I think I would just fit a Vaillant and the 90 deg plume elbow!

 

[mfgs]

Whats the gap between the two flues?
Plume kit will sort yours out, only concern would be the neighbours flue POC being drawn into the air intake of yours. But looks far enough away to not be an issue

 

[ShaunCorbs]

It's one of them you can only do the best you can, anything is better than it is atm

You need 1.5m between both air intakes

It's going to be a very hard gas run tho

 

[king of pipes]

400x400 slabs so 1600mm or so need a rear flued boiler so i can keep the boiler up higher under the stairs not keen on that either the stairs being the main route of escape but got to work with what i have thinking ideal logic + with a plume kit + a extra 1m lenghth to get me up and away above head height . cheers kop

 

[ShaunCorbs]

400x400 slabs so 1600mm or so need a rear flued boiler so i can keep the boiler up higher under the stairs not keen on that either the stairs being the main route of escape but got to work with what i have thinking ideal logic + with a plume kit + a extra 1m lenghth to get me up and away above head height . cheers kop

Agree but ideal ooooo

Eco blue or 400

 

[king of pipes]

Not much between em shaun fitted a few of each now the plastic case on both is a mistake in my mind but rear flued i am limited so ideal is my choice . cheers kop

 

[Harvest Fields]

Not much between em shaun fitted a few of each now the plastic case on both is a mistake in my mind but rear flued i am limited so ideal is my choice . cheers kop

What about a Vaillant?

Edit due to poor grammar.

 

[jtsplumbing]

Just done a logic cost of plume kit is over priced for what you get in it, but using one is your only option

 

[Gasmk1]

Ear ent glow work rear flued as well

 

[king of pipes]

Yes mate they do one, not much between em really 7years manufactures warranty on a18kw logic + fitted quite a few with no issues till they changed to the plastic cased mk2 version did one this time last year just serviced it this week no problems may aswell earn my points on installer connect got me some logoed gasafe workwear recently. Cheers kop

 

[king of pipes]

Well a quick update fitted a baxi 400 with a plume kit logic was 100mm bigger so would not fit alls good happy warm customer , cheers kop

 

[king of pipes]

Sorted