Search the forum,

Discuss How to pipe a tundish to a 22 mm vent pipe? in the USA area at PlumbersForums.net

Messages
13
Hello everyone I’m just wondering how you go about piping a 22 mm vent pipe into a tundish when the inlet on the tundish is 15 mm and the outlet is 22 mm. Attached is a photo of the vent pipe from the cyclinder going into the CWST that needs redirecting into a tundish then to a drain.

Many thanks for the taking the time to read.
 

Attachments

  • D9861C47-7CE9-4947-BD31-7C7DA8971AB4.jpeg
    D9861C47-7CE9-4947-BD31-7C7DA8971AB4.jpeg
    114.3 KB · Views: 19
Or you can make your own
 

Reply to How to pipe a tundish to a 22 mm vent pipe? in the USA area at PlumbersForums.net

Similar plumbing topics

Just started gound work on self build bungalow and wondering best way to do below ground soil pipes. For toilet I was going to go straight down through slab and out through deadwork into a manhole. I will work out falls from manhole and set the height of the waste water system as required. For...
Replies
2
Views
113
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
188
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
243
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
231
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock