W
Whyme
keep a few pushfit stop ends in ur pockets for code red (brain dead) situations.
Discuss Hints, tips & secrets of plumbing - No Banter please! in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Yes, sorry but the floors are not so good down here as the granite you may be use too TamzBrass 3" 12's do me Chris. I certainly wouldn't use a frame fix.
Brass 3" 12's do me Chris. I certainly wouldn't use a frame fix.
when fitting rads under a window sill measure down from the sill for top of bracket height fix brackets pop rad in place check levels and whichever side is the high spot pop the bleed valve on . I go to quite a few complaints (not my jobs) that are rads that seem un level when infact its spot on but they look out because of the sills
чIf every using anybody else's electric appliances or set ups, in my case my uncles set up for the light in his loft......
Just have a quick check for obvious defects or potential problems.
I got a belt from a horrific DIY job where my uncle had wired a plug on both ends of a flex to power the light in the loft.
I didn't check this and when I unplugged one end, it was still live as other end was plugged in and it hurt!!
ч
Tell uncle never to play with electrics like this ..... Is this even allowed !?
No way is it allowed. It's like allowing a plug with a flex and 3 exposed wires. Pins on the plug are just the same when the other side is live
To aid adding inhibitor, leak sealer or cleaner ect Make one of these up, keep compression fitting loose as then u can keep filler upright and tighten into rad. Take blanking plug out of other side as it avoids gurgling.
Solder a bit of 15mm into a 1/2 to 3/4 rad stump. Attach to hose. Draining down via a rad or makes syphoning easier. If rads are 15mm tail type just attach 3/4 valve and use 15mm connection.
Get a ladder base mate
Then ur ladder will be a lot safer when ur on the 3rd floor roof. Or helping dickie of his horse. Also a ratchet strap fastened to wall will make u a lot safer !
Need to change a syphon that wont flush.get a hose that is long enough to reach the pan and suck. Oviously not while in the pan. If its low enough the hose will syphon out the water and you can whip it off the wall without being full.
Bloo loo tastes worse than diesel. I'll stick to a sponge :wink:
Wet vac.
Wet vac indeed. But if you dnt have one. Oh yeh tamz, like limescale on cylinder when drainoff dnt work lol.
For guitar players, a short length of chrome plated 22mm makes an excellent slide!
To aid adding inhibitor, leak sealer or cleaner ect Make one of these up, keep compression fitting loose as then u can keep filler upright and tighten into rad. Take blanking plug out of other side as it avoids gurgling.
yes of course if it has one that's openablei open the other vent
over the front door works for meWhen you need to drain off only an upstairs but have a great drain point downstairs, hang your hose in a tree/ garage roof etc.
over the front door works for me
Reply to Hints, tips & secrets of plumbing - No Banter please! in the Plumbing Jobs | The Job-board area at PlumbersForums.net