Search the forum,

Discuss Hi! My nickname is Glow and am a new member! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
1
I have just had a new Worcester Bosch gas boiler fitted i.e. not combi by a professional firm! However I have noticed that when I put the heating on, two of my radiators in my living room seem to each have cold spots one side! None of the other six radiators in my house have any cold spots! I have tried bleeding them but does not seem to make any difference! Appreciate any advice on this! Thanks
 
Turn half the good ones off do the problem two heat up evenly?
 
Welcome along matey. Was the system flushed? Could just be an air lock. If you have trv’s on the rads turn them off put the heating on and open one of the ones that is not working to see if it clears it then do the other one.
 
Hello Glow,
Welcome along.

You could try shutting all rads which are heating in full to force the heat through the rads which have cold spots.
 
Status
Not open for further replies.

Reply to Hi! My nickname is Glow and am a new member! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi all, this is probably a daft question but I need to run my cold feed from one side of my wall mounted boiler to the other. Running it beneath the boiler is difficult with lots of obstacles, is it okay if I run soldered copper over / across the top of the boiler? It'll be about 4" off the top...
Replies
2
Views
170
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
263
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
236
P
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
163
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
289
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock