Discuss hep20 help needed. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
G

gasso

is anyone experienced with hep20 plastic 22x10mm 4port manifolds.they differ from the other fittings (bends ts etc)slightly, are the10mm ports demountable.ive tried and had no joy.help!
 
I though all the Hep2o range was supposed to be demountable... Have you got the proper key for it?
 
got the set.dont even need them to remove pipe from bends ts etc.but the manifolds have different ends.
 
Sounds like your using a mix of fittings, as far as I know all Hep fittings are white now and all require the demounting tool to remove pipe from them? You got a photo?
 
Status
Not open for further replies.

Reply to hep20 help needed. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

    • Like
Hi, I need some help on this shower drain installation. I’m about to install a corner shower kit in my basement bathroom. But I just found out the...
Replies
9
Views
803
Hi, Could anyone offer me any advice as to how to remove the top from this tap? I’ve tried twisting, pulling etc. but all to no avail. Short of...
Replies
2
Views
646
I am starting a large victorian renovation and it will involve, (amongst everything else) installation of an entirely new heating and plumbing...
Replies
8
Views
840
    • Like
Hello hello,, Hoping there are some experts or experienced Bulgarian plumbing chaps in this site ?. Here in the UK I can fit a bathroom just with...
Replies
2
Views
298
Hi Everyone I wasn’t sure whether to post this in here or UFH but hopefully I’m posting this in the correct group. I’m in the throes of a full...
Replies
7
Views
798
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock