Search the forum,

help needed please

Post new thread

Discuss help needed please in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
J

Jimjam09

Messages
2
hi
i need a little help building my portfolio im willing to work for free and at absolutely no cost to the engineer im in the ss12 area and would be so greatful if anyone out there could help
best regards
jim
 
Status
Not open for further replies.

Reply to help needed please in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
293
oz-plumber
O
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
118
Lou
Lou
R
Multi Meter which one for engineers
Can anyone recommend a decent multi meter, preferably under a 100 pounds. It's for checking boiler components so I don't need a top spec one ....just easy to use and reliable. The fluke 115 looks good but its above my budget. My current socket and see one was great but it's developed a fault.
Replies
7
Views
222
oz-plumber
O
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
227
DIwhYdidIstartThis
D
P
LCS to new water mains
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
193
ShaunCorbs
ShaunCorbs
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock