Search the forum,

Gas fire manual

Post new thread

Discuss Gas fire manual in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

macackau

Afternoon, trying to track down the manual for a DFE fire. From what I can figure out it might be a Monarch H14, but this doesn't. Bring anything up on google. All it says on the data plate is Model H14.

Can anyone point me in the right direction?

Thanks.
 
Status
Not open for further replies.

Reply to Gas fire manual in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Stigster
Does anyone know the name of this model of Roca toilet?
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
140
Stigster
Stigster
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
140
Lou
Lou
S
Using coil to clear pipe leading to gutter
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and pebbles!) We saw that the pipe that takes water down the gutter was visibly full to the top. He said he will return with a coil to push through...
Replies
2
Views
91
Sonya K
S
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
255
exedon2
exedon2
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
190
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

TilersForums.co.uk
Tiling Advice
Tile Blog
TilersForums.co.uk | UK Tiling Forum - Est 2006
UK Tiling Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock