Search the forum,

Discuss Free standing bath taps in the Plumbing Jobs | The Job-board area at PlumbersForums.net

king of pipes

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
6,157
Any of you come across this problem something is not right here ? Cheers kop

20180925_142401.jpg


20180925_142451.jpg


20180925_142417.jpg
 
Grub screw on the tap end ?
 
Flexi end fits down to the deck via the blue steet plate then chrome cover hides it up I think they are the wrong taps no grub screws in the legs either ? Soak .com should be Rubbish.com ,customer service crap not a clue . Kop

Screenshot_20180925-202803_Chrome.jpg


Screenshot_20180925-202742_Chrome.jpg


Screenshot_20180925-203516_Photos.jpg
 
Well come on share the fun
 
Look way down in there is a a female 3/4 bsp thread wasnt obvious and no fitting instructions soak.com confirmed correct products but no manufactures fitting instructions available, now fitted and connected into the supplies so time will tell floor to be plyed karndean going down walls to be paneled then it's fitting out . Cheers kop

Screenshot_20180925-202803_Chrome.jpg
 
To be honest if I had to make a connection to a tap that I couldn't leak test a flexi or a speedfit hand tight connector would be my top choice. Check all surface clean and smooth, no debris, nipped up past hand tight, no twisted, chances of a leak are miniscule. But would still rather be able to check!
 

Reply to Free standing bath taps in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
170
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
7
Views
304
Hi All, Looking for some advice on my little bathroom project. I took the bath out. I got a shower jacuzzi thing. The base has 2 wheels in the corner. Do I assemble the unit first attach water and elec, and slide the very heavy unit in on the two wheels? Or do I get the base in the corner and...
Replies
2
Views
101
D
Pipes for thermostat shower have been fitted at different heights. Any way of rectifying without ripping all tiles. So for clarity 15mm pipes sunk into wall behind bath. Walls have fresh tiles. Have realised as about to fit shower these pipes one is set higher than the other. If you fit a...
Replies
2
Views
218
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
377
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock