Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Discuss Flush valve replacement. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
101
Does anyone recognise this flush valve? It's broken and tends to let water pass ...
IMAG0123.jpg
IMAG0122.jpg
IMAG0124.jpg
IMAG0123.jpg
IMAG0122.jpg
IMAG0124.jpg
 
Looks very cheap and nasty. I have replaced relatively similar-looking mechanisms because they were not working. You don't have to stick with the same make and model flush valve, you know.
 

Reply to Flush valve replacement. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my...
Replies
3
Views
566
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The...
Replies
6
Views
259
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
254
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up...
Replies
2
Views
273
PSxxxxxx
P
I have a green star ten yrs old keeps increasing pressure, feel on off filling valve not working, drain off to recommended, but after few days...
Replies
1
Views
190
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock