Search the forum,

Does anyone use a Hilmor EL3B PIPE BENDER?

Post new thread

Discuss Does anyone use a Hilmor EL3B PIPE BENDER? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
W

wetdrip

Plumbers Arms member
Plumber
Messages
1,609
Do any of you guys use a Hilmor pipe bender code EL3B?
Seems most use Hilmor CM35.
 
That's what I was trying to verify.
What's the difference as their mechanical properties look the same, only formers and guide sizes that differ; true or false?
I don't know, so thought I'd ask.
 
Last edited:
Think it's just the guides that differ but a full set of guides will cost you nearly as much as a new unit from bend it now!
 
Status
Not open for further replies.

Reply to Does anyone use a Hilmor EL3B PIPE BENDER? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Stigster
Does anyone know the name of this model of Roca toilet?
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
163
Stigster
Stigster
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
220
dreikher
dreikher
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
334
oz-plumber
O
M
Unvented discharge at high level current regs
Hi they used to say as a last resort you could discharge the D2 pipework at high level and turn it back to the wall. Similar to a combi boiler. I have just looked back through the regs this seems to have changed and it isn't mentioned now. It now mentions if at high level it should be discharged...
Replies
11
Views
324
Matt0029
M
G
UK Moving Pipes Undersink for Dishwasher
Hello I am looking to install a slimline dishwasher (integrated) into a cupboard in my kitchen. The depth of the dishwasher is 550mm and the depth of my cupboard is larger than this. The issue, however, is that the waste pipe which leads from the sink (next door cupboard) comes out quite a...
Replies
22
Views
499
Basher
B
Creating content since 2001. Untold Media.

Newest Plumbing Threads

TilersForums.co.uk | UK Tiling Forum - Est 2006
Tiling News
Electrical News
DIY Forum
Plumbers Forum - Plumbing Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock