Discuss Crimping tool recommendations in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Reply to Crimping tool recommendations in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hi all. Hope you have all been keeping well.
A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to...
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic...
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going...
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is...
Hello all,
I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Newest Plumbing Threads
-
How much would you pay for a universal flush valve that enables replacements in under 5 minutes?
- Started by Professor
- Replies: 8
-
Bossing shower waste into soil pipe vs. separate shower waste- Started by CitizenErased
- Replies: 3
-
UK Advice on waste water pump in first floor flat
- Started by kbqwert
- Replies: 3
-
AM18x1 femail to 1/2" hose connector.
- Started by Adaminspace
- Replies: 0
-
Off grid shower and toilet solution needed
- Started by TpXThinnr
- Replies: 5
-
Expansion vessel size unvented hot water
- Started by Matt0029
- Replies: 2
-
Acrylic bath manufacturing standards/dimensions
- Started by Michelle
- Replies: 2