Potterton profile only has two screws, two big down bottom?, ( gas test nipple is I the middle right about where the crack is ) then swings out at top and lift off. Not going to do that with that cupboard!
Could be a PRIMA or Profile. Prima was negative pressure, Profile Positive. Can't tell unless you look inside the case,which is difficult unless you dump that kitchen unit. Flue goes out the back, but did have LH RH options. Centre of flue 64mm from top of case.
Ye the badge is on the inside bottom of the grey tray. But there's a screw under a flap to unscrew. Most of the time the trays are that badly damaged they fall off anyway. I'd say it was a prima, although they usually have a logo at the bottom right of the case.
Status
Not open for further replies.
Reply to Boiler Identification (potterton) in the Plumbing Jobs | The Job-board area at PlumbersForums.net