A
Albert2022
Is there a limit to the number of bends (90 def elbows or otherwise) you can put in the heating or drinking water pipe runs?
Discuss Bends in plumbing pipe in the DIY Plumbing Forum area at PlumbersForums.net
- Messages
- 34,363
- Solutions
- 2
nope just more turbulence in the flow
Reply to Bends in plumbing pipe in the DIY Plumbing Forum area at PlumbersForums.net
Similar plumbing topics
Hi, basic question, any insight much appreciated.
Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going...
Hello all,
I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic...
Newest Plumbing Threads
-
Pressure reducer/regulator for plastic water line?
- Started by carpetguardian
- Replies: 0
-
Cold water issues in the top bathroom
- Started by Apex84
- Replies: 1
-
-
How much would you pay for a universal flush valve that enables replacements in under 5 minutes?
- Started by Professor
- Replies: 8
-
Bossing shower waste into soil pipe vs. separate shower waste- Started by CitizenErased
- Replies: 3
-
UK Advice on waste water pump in first floor flat
- Started by kbqwert
- Replies: 3
-
AM18x1 femail to 1/2" hose connector.
- Started by Adaminspace
- Replies: 0