Search the forum,

Are Villeroy and Boch toilets OK?

Post new thread

Discuss Are Villeroy and Boch toilets OK? in the USA area at PlumbersForums.net

S

Steve_Oz

Messages
1
I am renovating my toilet and thinking of installing a Villeroy and Boch toilet suite (model "O.Nova 2.0").

Does anyone know if Villeroy and Boch toilets are good quality? Are they better/worse than Caroma or American Standard?
 
There high end and normally top notch
 

Reply to Are Villeroy and Boch toilets OK? in the USA area at PlumbersForums.net

Similar plumbing topics

Stigster
Does anyone know the name of this model of Roca toilet?
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
157
Stigster
Stigster
T
Trying to source a dual-flush valve
Does anyone know where I can get one of these? Toilet is leaking into the bowl. This one pushes in with a half turn but I can't find one anywhere.
Replies
2
Views
213
Thomas J Marshall
T
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
545
Chuck
C
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
375
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
213
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electrical Advice | Electricians Blog
Tiling Tools
TilersForums.co.uk | UK Tiling Forum - Est 2006
Tiling Advice
Tiling Forums UK
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock