Search the forum,

Discuss Appliance enginer in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
H

H SHAW

Looking for kitchen appliance fitters / engineers.

Must be Gas Safe registered.

On target earnings of £50k + van + fuel + tools

Please contact Henry Shaw; [email protected]
 
50k? I'm not taking a pay cut! Tools would be handy tho my pipe slices are just chewing through now.
 
50k? I'm not taking a pay cut! Tools would be handy tho my pipe slices are just chewing through now.

wtf hope thats a joke im just on just over 1/5th of that :D
 
Status
Not open for further replies.

Reply to Appliance enginer in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
221
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
223
  • Sticky
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from each main country too. I'll post this in the Australian forum now.
Replies
0
Views
71
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock