Search the forum,

AGA servicing course

Post new thread

Discuss AGA servicing course in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
C

CXR100

Plumbers Arms member
Plumber
Gas Engineer
Messages
889
can anybody recommend a good aga servicing course? don't mind traveling to the right place
thanks
 
A mate of mine that works on AGA cookers went to somewhere in Telford but that was a few years back may have moved by now.
 
Status
Not open for further replies.

Reply to AGA servicing course in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

R
Multi Meter which one for engineers
Can anyone recommend a decent multi meter, preferably under a 100 pounds. It's for checking boiler components so I don't need a top spec one ....just easy to use and reliable. The fluke 115 looks good but its above my budget. My current socket and see one was great but it's developed a fault.
Replies
7
Views
236
oz-plumber
O
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
481
FozzieBear
F
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
303
oz-plumber
O
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
524
Chuck
C
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
5
Views
151
Timmy D
T
Creating content since 2001. Untold Media.

Newest Plumbing Threads

British Standards in Tiling BS5389
Tiling Advice
Contractor Forum
Electrician Talk Forum
Tiling Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock