Accessing Flexicom 24hx installer cartridge

[ShaunCorbs]

No, I'm trying out an esp32 based ebus adapter that works with ebusd (I can't paste a link, sorry! I tried but it wouldn't let me post)

For control via home assistant?

 

[tony435]

For control via home assistant?

yep

 

[ShaunCorbs]

yep

Just a note you can’t alter the boiler temperature below 60 degrees

 

[tony435]

Just a note you can’t alter the boiler temperature below 60 degrees

Thanks, good to know Are you doing the same? Did you manage to change the flow temperature using the "SetModeOverride" method? So far I have it reading everything into HomeAssistant but I've not tried setting it via that method yet as some of the state I'm seeing looks a bit different to what I've seen online.

 

[ShaunCorbs]

Thanks, good to know Are you doing the same? Did you manage to change the flow temperature using the "SetModeOverride" method? So far I have it reading everything into HomeAssistant but I've not tried setting it via that method yet as some of the state I'm seeing looks a bit different to what I've seen online.

Some what but the issue is you will need to do dual temp eg 60 for heating the cylinder up to kill legionella and then your desired flow temp for the rads eg 40

 

[tony435]

Some what but the issue is you will need to do dual temp eg 60 for heating the cylinder up to kill legionella and then your desired flow temp for the rads eg 40

Right, yes that's exactly what I was planning on doing. Dropping the temp when only the UFH is active and raising it when the HW is on.

 

[ShaunCorbs]

Right, yes that's exactly what I was planning on doing. Dropping the temp when only the UFH is active and raising it when the HW is on.

If the boiler allows that the older gloworms were problematic to say the least don’t turn it off for long periods it might not come back on

 

[tony435]

If the boiler allows that the older gloworms were problematic to say the least don’t turn it off for long periods it might not come back on

Hah ok thanks! It all seems to be working well now, but I'll keep an eye on it