I am thinking of buying Rothenberger-Force-Pump to clear a blocked toilet ( when needed) but as its a bit on the pricey side I wondered if someone has any information on them before I buy
Thanks
I am trying to undo the non return valves on my shower to clean them but they won't budge, I guess there is a tool for doing this but can't find one on line - help would be appreciated!
It's basically a very wide slot but my largest screwdriver does not do the trick, the maintenance...
I am trying to undo the non return valves on my shower to clean them but they won't budge, I guess there is a tool for doing this but can't find one on line - help would be appreciated!
It's basically a very wide slot but my largest screwdriver does not do the trick, the maintenance instructions...
Which make is fairly foolproof? I tend to almost always go down the mechanical unblocking route but I want to leave a few bottles for a few tenants (not mine).
Hello all our university is doing a project to build a rocket engine, we would need somewhere where we could learn how to choose the fittings, valves, fuel lines, and what attributes each have. we will be using two propellant to feed the engine the first one is liquid oxygen which is a cyrogenic...
Hi,
Hope you can help with a central heating issue. I tried turning the central heating on today but without success. The orange light that usually comes on when the heating is triggered isn't illuminating - I've tried the once, twice and fully on modes and it doesn't come on in any of these...
Hi all.
Was looking at the Milwaukee transfer pump and wondering if it was fit for purpose ?
I’m doing new build and use a drill pump to pressure test and thought this piece of kit might make life a bit easier ?
Any thoughts please? Thank you.
Hi, I'm about to install a UV water treatment and filter system with 3/4" brass connectors. So I need to buy MDPE pipe connectors, bends etc. I wondered what folk thought about Plasson, FloPlast, Other connector types, especially the plastic to copper connectors, which I believe strip easily...
I've found this website called gasqet.com. They make 3D printed washers made out of a different plastic that is higher spec apparently, so it's a lot stronger, and recyclable (though why you'd want to, I have no idea). But they are the same price as normal washers.
Has anyone tried them out...
My bathroom tap is dripping water, I want to change the tap valve, but I don't know the valve size, if somebody familiar with the type of tap, please tell me the valve size. Thank you in advanced.
Hi all where can I get a aco 202 serviced/ repaired and then callabrated, having a real pain trying to find someone to do this,for such a well know tool thanks
Hi everyone, I think this topic may have been covered before? I'm looking at getting a press gun, more specifically the Novopress, it's just my preference as I've used this and the REMS mini press. I have heard rumors that angled jaws may be on the way for the Novopress but nothing concrete...
Looking to get one of these for a while and just got a job that's perfect for it to save me a fat drain down on a very old property, which one do you guys who use them rate, this place has 28mm return so ideally something suitable for that. Cheers.
Grohe kitchen mixer with new - fangled tool free fixing. Had 2 now, both with problems on the clutched plastic backnut - just keeps slipping and turning, not gripping - tap is about as solid as a fresh mackerel.
They are trying to make it easier for diy / handyman but usually it's the water...
I'm looking for a hole cutter or hole punch that you would use to cut a hole in a stainless steel sink for the waste to install into. Standard hole punches between 40 and 100mm for use with a hydraulic hand tool are available but I need a punch that makes the recess as well or a separate...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.