Search the forum,

Discuss zone valve actuator motor in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
E

evsy01

anyone know of any instructions on how to change a motor? tried it a couple of times but failed. any suggestions would be appreciated!
 
unclip the drive unit and replace with new drive unit, simpleessss Not being funny but if you cant change a sychron motor just fit a new motor drive to the valve, take the old one home and have a practice slow time.
 
when i take the motor out and put the new one in its as if the cogs underneath dont realign properly and just doesnt work properly.
 
when i take the motor out and put the new one in its as if the cogs underneath dont realign properly and just doesnt work properly.
Are you removing the Actuator from the valve to do this?
If so, you should lock the valve into the open position before removing it otherwise you can have problems with the cogs
 
Status
Not open for further replies.

Reply to zone valve actuator motor in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock