Search the forum,

Discuss Will this have an external filling loop somewhere? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

WaterTight

Esteemed
Plumber
Subscribed
Messages
5,439
Customer hadn't seen one and proved tricky to locate.

I know some are topped up from underneath with a couple of switches or whatever which I've managed to suss out before but couldnt spot anything for this one so I'm thinking it must have a loop somewhere else? If so I'll tell him to get hunting.

Thanks

22781990_10155114012795897_1533130195_n.jpg
22812924_10155114012780897_500638702_o.jpg
 
I would say compact si
 
Much easier to fill also. But typical that install only engineer never explained how to top pressure up. (or so customers say) :p
 
Status
Not open for further replies.

Reply to Will this have an external filling loop somewhere? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
99
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
78
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
230
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
176
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
166
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock