- Messages
- 653
Decided to remove content as not appropriate.
Thank you 2 members who pointed this out to me.
Thank you 2 members who pointed this out to me.
Last edited:
- Thread starter Jim Goodenough
- Start date
- Replies 4
- Views 2K
- fixings oil pan toilet
Discuss WC / toilet pan fixings in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 10,444
Naughty naughty.
- Messages
- 34,332
- Solutions
- 2
- Messages
- 10,444
Think we had already said enough matewill let it go as it's only pan fixings
. The other one has been sorted.- Status
Reply to WC / toilet pan fixings in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner.
The pan perimeters...
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking?
This originally happened about 12 months ago and has happened 3-4 times since.
It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
- Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
-
Mixer mixer shower, compatible with tanked supply
- Started by Matt0029
- Replies: 2
-
-
No Hot water, Fixed and Broken Again Ideal Logic 24
- Started by Filthbags
- Replies: 1
-
-
What's happening to this radiator, paint flaking off?
- Started by mikmikmikmik2024
- Replies: 2
-
Is it necessary to earth bond a Kitchen Sink?
- Started by Cello
- Replies: 4
-
Show us your fanciest radiators you have installed!!- Started by Lou
- Replies: 0
-
Y Plan, no hot water but heating is working when called
- Started by Chopper9495
- Replies: 8
-
-
Towel Rail Valve Advice please (35 Characters needed.)
- Started by NorthernLad
- Replies: 7
-
Unvented discharge at high level current regs
- Started by Matt0029
- Replies: 11
-
Trying to source a dual-flush valve
- Started by Thomas J Marshall
- Replies: 2
-
-