Search the forum,

Tpcp1 and 1a how hard are they ?

Discuss Tpcp1 and 1a how hard are they ? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
T

thrillseeker

Messages
6
Doing them both on Wednesday can someone tell me what it's like please never done it before.

Thanks
 
thrillseeker said:
Doing them both on Wednesday can someone tell me what it's like please never done it before.

Thanks
Click to expand...

I find it OK but I've always had Commercial/Industrial.
More calcs, more thought, no generalising really, each installation taken on its own merits!
 
How are you on math

If your good with it you will fly through it most of the ones when I resit struggle with maths and they fined it hard
 
Are you doing Pre training and Assessment or just straight into Assessment?
Have you done/seen any real life work on it?
 
I have done it 4 times you need to do the training and be good at maths, glad i dont have to do it anymore ha ha good luck though. Kop
 
Status
Not open for further replies.

Reply to Tpcp1 and 1a how hard are they ? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

A
Danfoss tp9000 programmer
hi could someone please tell me how a Danfoss tp9000 programmer with a remote sensor is wired to an existing s plan system?
Replies
2
Views
296
andcarpenter
A
B
Leaking TRV
Hi I have a leaking TRV on a downstairs radiator and need to get it replaced/fixed. Can anyone on here tell me the average cost to have this done professionally please?
Replies
3
Views
271
Belxvs
B
L
Toilet flush pressure question
Hello, I have a question on flush pressure. When I press the bigger button, there's hardly a flush. I understand that's normal but it's a very minimal flush. And then the smaller button is quite hard to press and I think doesn't do a full flush either. So when I flush I press both and it works...
Replies
8
Views
256
loted932
L
H
90 ° Isolating Valves
Can anyone please tell me where I might purchase a 90° bend 15mm x 22mm Isolating Valve Thanks and Regards. Hugh
Replies
2
Views
231
hughglenure
H
J
    • Like
Drain Rods - Which are Best?
Hi everyone, I've had rods break and come apart before and I can't go losing them up a customers drain, so recommendations please...... Which drain rods do you recommend, for a tradesmen, not a DIY set? And/or how can I tell a good set from bad?
Replies
7
Views
600
Ben-gee
B
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock