Search the forum,

To ogle at Beavers click here...

Discuss To ogle at Beavers click here... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
gmartine

gmartine

Esteemed
Gas Engineer
Messages
2,340
Really good for joist drilling and small enough in length for a normal sized cordless or impact driver, far superior to a flat bit or auger imo...

Armeg Stubby Wood Beaver Set 3Pcs

Armeg Wood Beaver Drilling Set 4Pcs
 
Last edited:
Very good also handy are the nail proof ones
 
Nail proof versions too? Fab, only used them recently when bolting joists together then threw my auger bits in the bin.
 
gmartine said:
Nail proof versions too? Fab, only used them recently when bolting joists together then threw my auger bits in the bin.
Click to expand...

Yes not too bad either
 
Status
Not open for further replies.

Reply to To ogle at Beavers click here... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
117
dreikher
dreikher
C
Mira shower mixer adjustment.
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
195
cheddarman
C
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
214
ShaunCorbs
ShaunCorbs
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
3
Views
158
Last Plumber
Last Plumber
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
255
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock