Search the forum,

Cotherm GTLH3161 Cylinder Stat

Post new thread

Discuss Cotherm GTLH3161 Cylinder Stat in the Central Heating Forum area at PlumbersForums.net

J

John.g

Esteemed
Plumber
Subscribed
Messages
3,973
What is/should be the switching differential in the above, installed in a Heatrae Sadia unvented HW Cylinder, set to 60C. Can't find anything in the spec sheet re this.
 
Normally around 15c differential but it all depends on the contact with the pocket
 

Reply to Cotherm GTLH3161 Cylinder Stat in the Central Heating Forum area at PlumbersForums.net

Similar plumbing topics

B
Unvented hotwater cylinder
Fitted unvented hotwater cylinder building control looking forms signed it off job was in england i am qualified northern ireland send out a form to fill in what do u need to sign off in england as building control said they dont give out forms like they do in northern ireland
Replies
4
Views
204
ShaunCorbs
ShaunCorbs
M
Central heating losing pressure all the time
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
178
PSxxxxxx
P
A
Emergency Stop Buttons in Boiler Rooms
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
264
oz-plumber
O
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
133
Lou
Lou
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
231
DIwhYdidIstartThis
D
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Forum UK
BS 5389 Tiling Standards
Electrical News
Tilers Forums UK
Tiling Forums UK
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock