Search the forum,

Discuss Boulter Camray oil boiler cuts out but starts if front cover removed - Any ideas? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
L

lodgey47

As title when my Camray starts up it runs for a few seconds then stops. A few more seconds later it starts again then stops again...... and so on. What I've found is if I partly remove the front air tight cover it runs fine with no problems. It was serviced over the summer but can't get the engineer back now until after christmas. The fan is quite, oil pump seems ok, flue isn't blocked, plenty of oil. Any ideas?? Cheers
 
It sounds like burner is being starved of oxygen, it either needs the air increasing on the adjuster, best done with a flue gas analyzer. Or its recycling its own flue gases because the flue seals have gone
 
Could also be the combustion chamber access door joint leaking, has it been off recently.
 
Status
Not open for further replies.

Reply to Boulter Camray oil boiler cuts out but starts if front cover removed - Any ideas? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
219
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock