- Messages
- 34,309
- Solutions
- 2
anyone know if we can get these in the uk ?
- Thread starter ShaunCorbs
- Start date
- Replies 6
- Views 2K
- elbow plate
Discuss ...Back plate elbow ?? ... in the Plumbing Jobs | The Job-board area at PlumbersForums.net
W
Welder
I've never seen on Shaun. One teh odd occasions I've needed something like that I've used a wallplate elbow. Nowhere near as neat but worked!
- Messages
- 34,309
- Solutions
- 2
Yea was hoping for as tight as pos as it's behind a shower and no need for a male iron
- Messages
- 66
Looks very neat, Did you take the picture? Looks like there might be markings on the side.
Would be keen to order some if you did find them.
Would be keen to order some if you did find them.
- Messages
- 6,157
Cant find any mate be interested if you find em . Cheers kop
- Messages
- 2,137
Looks like USA only but you can get them shipped not cheap 1/2" Lee Brass Drop Ear Elbow 90 Ell C X C Solder SWT FAST SHIP! EE7 | eBay
Reply to ...Back plate elbow ?? ... in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hi All
I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Hi, basic question, any insight much appreciated.
Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT.
THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE.
THANKS
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-
-
Sewer pipe problems not sure about it- Started by sammie81116
- Replies: 3
-
-