You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
unusual
Cruel and unusual punishment is a phrase in common law describing punishment that is considered unacceptable due to the suffering, pain, or humiliation it inflicts on the person subjected to the sanction. The precise definition varies by jurisdiction, but typically includes punishments that are arbitrary, unnecessary, overly severe compared to the crime, or not generally accepted in society.
Hi All,
I'm plumbing in a washing machine into our new house and rather than a normal waste pipe this house just has a hole in the ground. It looks as if the hole used to be a 40mm pipe but it has been sawn off at ground level such that the top of the pipe is flush with the floor tiles. This...
Hi,
I have a problem with Viessmann 111w
I have a Vicare sensor and app.
It goes like this :
If I have a boiler in DHW only everything works as it should, but then I switch it to DHW and heating. Temperature in a room is 21 degrees. I set the boiler to come on when the temperature is 17...
Hi,
I have a problem with Viessmann 111w
I have a Vicare sensor and app.
It goes like this :
If I have a boiler in DHW only everything works as it should, but then I switch it to DHW and heating. Temperature in a room is 21 degrees. I set the boiler to come on when the temperature is 17...
I've got an issue with an ageing worcester 24i junior.
It seems to run fine but often trips RCD just after using HW.
I couldn't find an issue but checked and cleaned all contacts and checked terminations in socket and plug (it is a caravan if that makes a plug ok IDK?)
It's definitely...
Hello,
Recently I received an unusually large water bill which led me to the discovery of leaking flush valves. I have two toilets and it turned out in both the valve seals were bubbling so I set out to replace them. For now I just flipped them over as the other side was smooth on both.
The...
I have a leaky tap, so I thought I could fix this with replacing the washer, however, when I took the cap off, I could not get the wrench in there to grab hold of the nut to turn! This is because the nut part of the cylinder is sunk into the casing (please see photo in the attached links)! I...
I found a concrete slab buried in my back yard where the drain field is supposed to be. It appears to be "L" shaped 22.5' X 21.5' on the long sides and 5' wide. It is about 8" deep, hollow with baffles. From the open ends I can see rocks inside, but have not gone too far into exploratory mode...
when the kitchen sink is being used without the plug in, the water drains really slowly and backs up for a few seconds. But when I put the plug in, fill the sink up all the way to the top and take the plug out it drains really quickly, I have taken all the plastic pipes out underneath and...
First post so greetings to all!
We have a problem with our elderly Potterton boiler and its Grundfos pump as follows:
Boiler started behaving erratically, switching on & off at short intervals
Within days boiler stopped coming on at all
Noticed that Grundfos pump was making an unusual sound as...
Hello
I am trying to find out what has caused these small circular shapes on my guest toilet's ceiling. Is it water damage or from some cleaning or steaming that was done on the wall tiles?
Thank you.
I have a boiler (Potterton Promax 15SL) and after it has been heating the house for a while, when it turns off, warm air gently comes out of the fan unit (which is now off) and the air hits the metal housing of the boiler and condenses, causing it to pool in the bottom of the boiler and...
My father's bath has unknown make tap heads, which turn one way for the side filler & the other for the shower. The heads are a bit like upside-down saucepans but with rectangular block handles - the saucepan look was everywhere a few years ago IIRC (a bit like the pic 😂). However AFAICT...
Hi All,
I need to replace two radiators in on of my rooms. The size does not seem to be available from normal suppliers. I think it is an imperial size 32 wide by 16" high. I need to replace as they are not in great condition around the threads. You might see the corrosion in the image I will...
Hi – can’t turn this nut with serrated edges. Tried big pliers & gave stilsons a gentle go – but to no avail.
Since brushed it clean & found it’s chewed up a bit. What’s the best tool & process before I damage it further?
It’s dripping from spindle when shut off tight but trickling when open...
Hi all, I have a leak coming from a bathroom tap. It's coming through the lever - I've circled where the leak is in red in the attached photo. I can't work out how to access this part of the tap or what I should be replacing. There is a small grub screw that you can also see in the photo, but...
Is anyone familiar with the fixing on this 1960-70's "OSY" branded mixer tap knob?
I am trying to change the washers but there seems to be no obvious way to remove the knobs. There is no screw or nut to release them. It might be push-fit but don't want to force it before confirming that is the...
Hi Guys
I'd like your thoughts on this.
Customer has a 3 bar whole house shower pump and also an aqua lisa digital shower. Upon replacing the pump I noticed the water tank is only 50 gallons. It really should be 80-100 gallons? Its a 3 story town house with basement and two bathrooms...
Any idea how to get into the cartridge on this tap. I can remove the spout and also unscrew the sleeve on both hot and cold. No idea if there is a cap for the levers to remove. Thought for a while that it was an anti clockwise unscrew, but that doesn't work either :-(
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.