Search the forum,

temp control

Flex temp is a technique used to produce cost savings through increased engine life and reduced overhaul and fuel costs for airliners by allowing them to take-off at less than rated thrust.
For Airbus and Fokker aircraft the technique is known as flex temp or just flex. Other manufacturers use the terms Assumed temperature thrust reduction, Reduced take-off thrust or Factored take-off thrust.

View More On Wikipedia.org
  1. T

    Rayburn and water heating.

    Hi, seeking some advice on a Rayburn and control of hot water. Leaving out a very long story, my mothers house is about 200 miles away from me and she has recently moved into a care home. My brother and I need to renovate this from afar in order to rent it out to help with funds for her...
  2. P

    Ufh problems temp control and radiators temp

    Hi guys Our recently installed UFH system is causing us trouble and we are struggling to get the fitter to help, problem one is we have to slowly build up the heat as the new floor is tiled but the only way to do this is by turning the boiler heating controls down as low as it goes, 30 degrees...
  3. P

    UFH floor temp control

    Hello, We are having wet UFH installed across the ground floor of our house, about 5 zones. We'd like vinyl and timber and hence know we need to limit the floor temp to 27 degrees; question what are the ways to do this? We've seen the neo control system that can control on air temp and floor...
  4. A

    Vaillant 438, VR65, VRT392f and Megaflow connections

    HI , I wonder if there is someone out there who can help, i've got a Vaillant Ecotec 438 open vented Boiler , a VR65 control center and a Wireless VRT392F thermostat controls with a large Megaflow HE 250L tank. I have installed the VR65 as per Vaillants instructions, the Hot water and Heating...
  5. B

    shower valve and pump problem

    hi all, first time poster and any help would be nice recently fitted a hudson reed victorian exposed shower with rain head fed by a salamander ct50 boost pump the pump is fitted correctly,and constant good flow acheived when shower valve is removed however when valve is refit the flow is crap...
  6. D

    Most effective way to run the boiler.

    I have an oil, floor standing boiler.I have my CH on all day from 6am till 9pm, this is controlled by the room stat(temp control only). I then have to run the boiler flat out for 2 or 3 hours in the morning to again reach temp. My question is, would it be more efficient to leave the boiler on...
  7. M

    Ideal C80FF / 95FF constantly on

    I have had a call from a customer telling me that their Ideal C80FF / 95FF boiler is constantly on heating. even though the dial on the boiler is on the off position!. Im going to look at it over the weekend and was wondering if anybody has come across this problem? Cheers
  8. G

    Mira 722 'E' cartridge

    Hi our leaking shower might have a 722 E cartridge, the one with the spring. Does anyone know the exact difference between this and the other 722 cartridges and the reason for the spring. Also if the E is not available, what is the next best cartridge to use cheers Geoff
  9. D

    baxi instant 105e combi boiler

    when in hot water only mode,the temp control is in the off postion,hot water will run and the temp rises then knocks off for a few seconds and lights again the temp lights go on up until 80 degree then it knocks off,when it fires and i try and rotate the temp control for hot water the hot water...
  10. P

    Temp control

    I have just been chatting to a bloke who owns an office block with 15 offices. He was asking what would be the best way to control the temp in all of them, set it at 21 degrees max, his tennants always keep it on full and he want to control it. What would be the best system to us for this...
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock