You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
tap
Táp is a village in Győr-Moson-Sopron county, Hungary.
In 1588 it was undivided property of Count János Cseszneky and András Farkas, later was in the hands of Cseszneky heirs.
Morning folks,
I am staying with my son and something strange happened. My wife was washing her hands in the downstairs toilet and the tap in the kitchen started running water for about a minute then stopped. It's happened 3 or 4 times but not every time.
Any alive welcome.
Hi all,
I'm completely inexperienced at this, but my kitchen taps are ancient, and the water has started dripping. Rather than just change the washer, I want to change the entire thing to a mixer tap that supports two holes. I think I've figured most of it out except for the part where I...
Hi just purchased above tap it has 19mm flexi tails and want to fit to a standard 15mm isolation valve.
Is there an adapter available as isolation valve is male type, so 19mm flexi needs to screw onto standard 15mm coupling.
Any advice appreciated.
Hello
I have had to adjust a sink hight by several mm. Now my bathroom basin 300mm flexi is a fraction too short. It does up but under tension. Is there a bush of some sort that I could use to extend by a few mm. Ideally 1cm or more. I’m thinking that a 500mm would have too much slack. Or would...
Hi, I know nothing about plumbing 🤦♂️ and am trying to sort out a leaking kitchen tap. It's a Franke Davos 'J' Tap. I turned off the water to the sink and took off the screws at the end of the handles (also the spout, although that may not have been necessary). I thought the handles should just...
Customer wants an outside tap for dog washing so needs to be blended. The hot water is gravity and its a bungalow so little head at the point of installation. I can't get a cold from the storage cistern to the utility so it has to be mains cold.
Can pressure reducing valves be taken down to...
Hi, I can’t get one cartridge to budge when trying to replace in a mixer tap. The hot side cartridge was tight but removed with wrench comfortably, but cold side is so tight Ive burred the nut on the cartridge. Any advice on how else to remove the cartridge without damaging the mixer tap is...
Hi all, I have an issue with our shower's hot water. The shower is operated using two separate taps for cold and hot water. When the hot water tap is turned on, no water at all comes from the shower head - not even a drizzle. However, when the cold water is turned on it flows freely. The hot...
Dan0001!`
Thread
australia
coming
hot
hot water
no hot water
shower
tap
turned
water
I have a proboil 2x boiler for my instant hot water tap.
It has developed a leak from inside the casing. This is the 3rd boiler i have had now as replacements and all developing the same leak.
I live in a soft water area, any ideas what could be causing this or is this a known fault?
Hi,
Could anyone offer me any advice as to how to remove the top from this tap? I’ve tried twisting, pulling etc. but all to no avail.
Short of smashing the hell out of it, I’m stuck with it, the dripping and my wife’s moaning.
Any help gratefully received.
Cheers
Nick
Hi. I have a kitchen mixer tap unit with older washer type inserts which has a dripping cold side. I have a pair of replacement ceramic inserts to upgrade both but the cold side insert will not shift at all. It genuinely is so tight that I am in danger of damaging the mounting even though I am...
I purchased 2x 1/2” tap gland for my basin because the hot one was faulty.
I had to turn the stopcock of in the kitchen.
I also had to turn off the mains on the pavement outside.
I replaced the glands and the hot is working fine.
But the cold tap does not turn off at all, with the new...
Hi,
I am trying to fit a replacement tap to a mini-sink that's built in to the top of a toilet. The original tap isn't made any more by the manufacturers - the nearest equivalent is apparently this one: GoodHome Lazu 1 lever Mini Contemporary Basin Mono mixer Tap | DIY at B&Q -...
Can i add additional outdoor taps by extending an existing outdoor water line (exiting outdoor tap) or does it have to be from the water mains ? will it reduce the water pressure ?
To repack a stop tap gland with loctite 55. Are you best having the stop tap open before you back the gland off to repack? I have always done it with the stop tap off. Thanks
The handle on my hot tap has been eaten away. The same thing happened 2 years ago to the same tap. It looks like galvanic corrosion has anyone seen this before. The tap is definitely brass. The top is chrome plated.
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.