Search the forum,

overheat

"Overheat Night" (オーバーヒート・ナイト, Ōbāhīto Naito) (stylized as "OVERHEAT.NIGHT") is the second single by Japanese singer Chisato Moritaka. Written by Hiromasa Ijichi and Hideo Saitō, the single was released by Warner Pioneer on October 25, 1987. In contrast to the pop rock sound of Moritaka's debut single "New Season", the song uses a dance-pop arrangement."Overnight Heat" was also released as the B-side of the mini CD reissue of "New Season" on March 25, 1988.The video album of "Overheat Night" was released in CDV format on November 28, 1988.Warner Music Japan released the "Overheat Night (Extended Mix)" LP on November 3, 2019.

View More On Wikipedia.org
  1. P

    Glow worm back boiler

    Hi I have a Glow-worm back boiler which is giving me grief (I would have upgraded it by now but its a listed building and there's issues with venting through the external wall and I'm reluctant to go with an electric boiler instead (because of the consumption cost)). It's a sealed system. The...
  2. H

    Overheat stat on Grant boiler

    Following on from my question about monitoring F & R temperatures, I needed a measuring device because the overheat stat. frequently trips and then needs to be reset. It normally happens when the boiler has switched off and is no doubt due to the hot water rising to the top of the boiler, but I...
  3. B

    Ranco overheat stat replacement.

    Hi everyone. Pilot light extinction problem on an old Myson Economist has been traced to a faulty overheat limit stat. It's a Ranco LM5P8037 which is now obsolete. It's a 2A 30mv 110 degree stat with a coil inserted into a pocket on the flow outlet. Will any other Ranco limit stat with similar...
  4. D

    Potterton Prime Overheat Stat

    Evening all. Can anyone help me with a bit of advice. We “inherited“ a Potterton Prima 60F boiler (which we were told in 2013 was 3/4 years old). It turns out after checking Serial number with Potterton that it was manufactured in 2003. Had it regularly serviced but a few weeks ago it failed...
  5. E

    Why does my Ideal logic +30 boiler keep going in to overheat lockout.

    The boiler runs may be 1 or 2 days before erroring. The problem started 3 months ago. The boiler would run blue light on at front an center of boiler. But the pip work out would bearly get warm. The pump should has rust water dripping from Chrome screw hole and the divert value was also...
  6. N

    Overheat protection for a wood burner with back boiler install?

    Hey guys, I've searched the forum, but haven't found anything useful. I don't know the name of the thing I'm looking for, so I apologize in advance if this is something basic that I should have found in a search. So basically, my electrician is an old fella who doesn't know much about heating...
  7. S

    Potterton 80el Overheat stat keeps tripping

    Hi Guys, Have a customer who has a Potterton 80el and when running heating after a few hours the red overheat stat button at the bottom of the boiler pushes out and boiler wont fire up. Customer has said if they reset the button they heating could work for a few hours or for the whole day...
  8. C

    OVERHEAT BUTTON- GLOW WORM ULTIMATE FF BOILER

    This is a long shot-( this post was originally sent to StevethePlumber but I havent heard back from him as yet) I have a glow worm ultimate ff boiler. Pilot light not lighting. There is power in the unit as it is glowing orange inside the box with the control knob. Anyway, on the self...
  9. Steve weightman

    Halsted ace high HE Hot water overheating and pressure going high

    Need a little advice with the above boiler as there's no tech advice and boiler readings available. Just overheating and pressure going to 3 bar only sometimes with DHW demand. It's has a new plate heat exchanger. Many thanks
  10. W

    Grant vortex overheat reset

    Hi, I have a grant vortex oil boiler that keeps tripping the overheat stat. It is not a Combi boiler and happens at anytime of the day/night. Can someone point me in the right direction please.
  11. J

    E9 overheat error on zone valve switch

    Hi All I have a Worcester Bosch FS 30CDI with a traditional header tank and hot water cylinder. The heating circuit is divided into 3 zones: downstairs, upstairs and the hot waterr cylinder coil all controlled by Honeywell two port valves. When the boiler is set to Max about 86deg and is...
  12. W

    Intermittent Overheat lockout on a Worcester Heatslave 25/32 circa 2007

    hi I have an intermittent overheat issue (every 5-10 days) with a Worcester Heatslave 25/32. According to the customer the Dhw becomes scalding hot and the boiler then locks out on the overheat stat. So it’s locking out on the hot water side presumably. There are no external controls on the hot...
  13. V

    Booster pump installed successfully, but now boiler goes to overheat!

    Hi all, need advice as I am an amateur who wanted to improve things but made it worse. Ok, have a duplex apartment with a Baxi solo 2 gas central heating. All working ok but the gravity fed shower upstairs was slow in water pressure, and I found this cheap 0.9 Bar electric booster pump on Amazon...
  14. R

    Boiler overheat cutoff after new pump fitted

    About 4 weeks ago I had no hot water and there was a vibrating noise which seemed to come from the hot water pump in the airing cupboard and go down to the boiler in the kitchen. I believed it was this as if I fiddle with the hot water pump I could sometimes get it to stop. I had a plumber...
  15. M

    Potterton prima overheat problem

    I have got an ongoing issue with a prima 60F. Before I looked at it, someone had replaced the boiler stat and the overheat stat and the system had been cleaned. The problem is it keeps tripping the overheat stat, but not all the time, maybe once every 2-3 days. I found the inner flue was...
  16. G

    2 port on UV cyl return

    Any thoughts on putting a 2 port on a megaflo return, which has a 3 port only set up. There is no room or pipework space to get it on the flow to cyl after the 3 port. Whoever fitted it must have thought the 2 port was a billy bonus for stock. My thinking is better on return than not at all.
  17. R

    Boiler overheat tripping

    Hi All, First post, from a competent, trained Electrical engineer and ex Service engineer, DIYer and hobbyist. :-) The boiler Glowworm Ultimate (downstairs kitchen) has suddenly decided to pop the overheat trip. Never done it before and its not the first time weve run the heating this year or...
  18. S

    Glow-worm Hideaway FF: on, off, on, off, on......

    Scenario: - pumped CH in 22mm, Gravity HW in 28mm - stat and two channel programmer working fine - pump spinning (whole house gets heat within a few minutes) All as you would expect from a 2005 installation and the house gets heat and HW. Question: - how frequently should the boiler...
  19. D

    Sime format 100c overheat stat

    Has anyone fitted the overheat stat kit ? What' the best way to make the electrode grommet bigger to get the cable through?
  20. N

    overheat glowworm ultimate 40ff

    having a hard time on this job, replaced pcb as not working and all good. cust calls and o/h is now tripping about every few hours, replaced old board with new updated board - anyone had this issue or know of it? cheers
Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock