Hi to everyone, newbie here.
I have a waterfall mixer tap with a shower attachment which has started leaking. I have replaced both the ceramic disc cartridges, ensuring that everything was clean before hand but its still leaking. To enable the shower, you lift a knob which is situated in the...
I have a Kronos mixer tap from Wren kitchens: Kronos Tap Chrome - High/Low Pressure | Wren Kitchens - https://www.wrenkitchens.com/kronos-tap-chrome-high-low-pressure/79856
I need to replace the cartridge but am having trouble finding the part I need - the brand isn't listed on any of the sites...
Hi
I had new a new mixer tap installed a few months ago and at the time of install thought the pressure was too strong. So my plumber made adjustment it to reduce it (or the flow rate?!).
I've since decided i would like this increased. Would you be able to explain how i am able to do this as...
I have a Dorf mixer tap that is leaking from the body. A plumber has replaced the cartridge but it is still leaking when the tap is turned off.
Do these taps have other parts that need replacing? Suggestions would be most welcome.
Regards, Lyn
I have a kitchen mixer tap with one simple lever controlling temperature and flow. The street water was cut off for a few hours. After that, the hot water flow worked as before, but the cold water flow was very weak. With the tap set to cold, if I open the tap about half way, the flow is the...
Any idea how to get into the cartridge on this tap. I can remove the spout and also unscrew the sleeve on both hot and cold. No idea if there is a cap for the levers to remove. Thought for a while that it was an anti clockwise unscrew, but that doesn't work either :-(
I have a mixer tap on our kitchen sink and it's started to drip.
I c an see how it comes apart but how will I know which one is leaking once I open them up or should I just change both washers to be on the safe side?
Thank you.
My basin mono mixer (model No: ME00101) is 10 years old & leaks at the bottom base of the mixer stand & underneath the hand lever. Water is running down the LHS hose pipe as a drip. I closed the ball valve on the hose but water still leaks. (A) What is wrong with the mixer? (B) Is the mixer...
I have a Grohe "Eurosmart Cosmopolitan" mixer tap which doesn't turn fully to the right (cold). I fear some sloppy installation and/or an (unwanted) hot water limiter incorrectly installed. Anyway, the guy who installed it is long gone so I'm on my own DIY now.
I took the grub screw out no...
Hi
A while ago I replaced the o rings in my kitchen mixer tap spout....simply by removing the grub screw at the back of the spout and removing it in seconds. BUT I tried to do the same job on a friends mixer tap which is leaking from the bottom of the spout where it meets the base. HOWEVER...
Kitchen mixer tap, took off handle, no idea how to take out cartridge/valve leaking, on the back there’s a hole for an alley key, doubt that’s it.
Looked at videos on YouTube, does make me wonder to put a rag over tap with a wrench to turn anti clockwise, but slips, I don’t know, run out of...
Hi, got a dripping kitchen mixer tap want to fix. Can't work out how to get cartridge out, not seen anything like the one we have on internet.
Please see attached. Any idea?!
Don't laugh... (too much)
We have a white mixer tap (20yrs old now) it needs replacing and I bought a very similar one yesterday.. it came with the flexible hoses as you'd expect but most don't seem to like.. anyway looking at it I couldn't see how it was piped in the first place. .all soldered...
I have a kitchen mixer tap which has developed a leak. It has been installed and without leaks for 18 years so I suspect a perished seal?
I attach photos of the mixer tap and the underside where it is weaping.
I would appreciate some advice on how to fix this.
I have a Roca bathroom mixer tap, when hot water drains through the trap there is a high pitch tapping noise which sounds like it’s coming from within the mixer or trap itself.
It’s not a knocking noise like the pipe rubbing on stud wall as it’s very a high pitch noise. Sometimes it can be...
Hi. We have been looking for a low pressure (0.2 Bar) dual control mixer tap and matching bath filler for our bathroom. The ones we like the look of are from Tavistock, Vado or Tre Mercati. Please would anyone on the forum with experience (good or bad) of these manufacturers taps give me some...
Hello,
I have a low pressure system, but it seems I have a high pressure tap.
I have amend some of the pipework to the tap anf put a full bore 15mm isolator on pipe to help keep the full flow, but the flex from the mixer are really small in diameter how can I over come this, or do I just need...
Hi,
I have recently moved in to a new home and upstairs is a bath with a tap mixer shower. However nobody knows how it works.
There is the tap then a pipe coming from the middle of the tap to a shower head on the wall. There is no button or switch of any kind and pulling it twisting doesn’t...
Hi,
I have a Twin lever Monobloc mixer tap leaking from the base of the spout, there are many answers to this problem online, however, the majority of issues are when the water is on and the tap is running, in my case, the base of the spout is leaking when the taps are off.
Would this mean...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.