Search the forum,

ground

In electrical engineering, ground or earth is a reference point in an electrical circuit from which voltages are measured, a common return path for electric current, or a direct physical connection to the earth.
Electrical circuits may be connected to ground for several reasons. Exposed conductive parts of electrical equipment are connected to ground, to protect users from electrical shock hazard. If internal insulation fails, dangerous voltages may appear on the exposed conductive parts. Connecting exposed parts to ground will allow circuit breakers (or RCDs) to interrupt power supply in the event of a fault. In electric power distribution systems, a protective earth (PE) conductor is an essential part of the safety provided by the earthing system.
Connection to ground also limits the build-up of static electricity when handling flammable products or electrostatic-sensitive devices. In some telegraph and power transmission circuits, the ground itself can be used as one conductor of the circuit, saving the cost of installing a separate return conductor (see single-wire earth return and earth-return telegraph).
For measurement purposes, the Earth serves as a (reasonably) constant potential reference against which other potentials can be measured. An electrical ground system should have an appropriate current-carrying capability to serve as an adequate zero-voltage reference level. In electronic circuit theory, a "ground" is usually idealized as an infinite source or sink for charge, which can absorb an unlimited amount of current without changing its potential. Where a real ground connection has a significant resistance, the approximation of zero potential is no longer valid. Stray voltages or earth potential rise effects will occur, which may create noise in signals or produce an electric shock hazard if large enough.
The use of the term ground (or earth) is so common in electrical and electronics applications that circuits in portable electronic devices, such as cell phones and media players, as well as circuits in vehicles, may be spoken of as having a "ground" or chassis ground connection without any actual connection to the Earth, despite "common" being a more appropriate term for such a connection. That is usually a large conductor attached to one side of the power supply (such as the "ground plane" on a printed circuit board), which serves as the common return path for current from many different components in the circuit.

View More On Wikipedia.org
  1. C

    USA Plumb rainwater to in ground cistern under house?

    I'm trying to pipe rainwater into my cistern under my house. I'm trying to find an overflow controle method. 4" auto valves are to expensive. Thought about putting a ring around in to raise the top up far enough to put an overflow pipe but I don't think I could get it to seal right. Is there a...
  2. T

    Ground Source trenches

    Hello All, newbie here. I am building a new home on a spacious plot and considering a ground source heat pump instead of air source. I understand trenches need to be 1.2m deep, 1m wide, and 5m apart. But how level does the overall site have to be? My site is on the side of a hill and the...
  3. dips31

    Ground floor heating not working.

    We shifted to a new house with 3 floors. The boiler is in the attic. We have problem with the ground floor radiators which is not heating at all. When we shifted a plumber removed one radiator in the ground floor we are not sure if that is the reason. Its a one pipe heating system. So many...
  4. J

    Extending Heating in to a Ground Floor Extension

    Just had a new ground floor extension built and the plumber has taken a feed from the main heating circuit from the boiler that runs under our easily accessible ground floor void, run 15mm speed fit pipes back up into the roof of the extension, and then fed back down to each radiator. We have...
  5. M

    pressure loss and air in ground floor rad and top foor towel rad

    Hi Towel rad in bathroom needs bleeding every few days and now noticed a small rad downstaris also has air in it regularly. Pressure drops every few days and needs topping up. I've tested with a flame for corrosion and it's clear, tried leak sealer and checked for weaping rad connections . I...
  6. J

    Radiators on ground floor stone cold

    Hi, We have a issue with our heating, where the radiators upstairs are roasting hot, yet the radiators downstairs are stone cold . We had a powerflush done the other day which didn't help ...Two radiators out of four (including lock shields and TRV's) on the ground floor where changed, but...
  7. G

    External pipes below ground level

    Hi not sure if this is the correct place for this, but does anyone know what these pipes are around 1foot below ground level, not sure if it’s tied in with the house plumbing system in any way at all. My property is only below ground level at one side as each house in the street is on a slope...
  8. A

    Ground floor toilet waste location

    Busy rebuilding an old bathroom in an old cottage. Bathroom is downstairs and on removing the toilet I can see it goes straight into the ground (see photo). We did want to site the loo about 3ft to the right but cannot for the an extension to the pipe through the cabinets. I could box off the...
  9. R

    Ground floor flat - intermittent sewer smell

    Hi All, I live in a ground floor flat and sometimes when the back door is open get a sewer smell come into the hallway. It's very intermittent and only happens when the upstairs flat is running water. There's two drains from upstairs, one from the kitchen and then one from the bathroom which is...
  10. N

    Different flow rates on ground floor

    Hi, I've bought a four bed house, it's about 20 years old and has an adjacent garage. It has a downstairs toilet, utility room and kitchen and upstairs there's a main bathroom and an ensuite shower room. It has a vented system with boiler in garage heating cylinder on landing and a 40 gallon...
  11. N

    How do I connect to this ground toilet pipe.

    Underfloor pipe. How do I connect? The pipe is made of pot I think and it’s broken. My flexible toilet pipe won’t go into it properly. It’s 10cm in diameter. Thank you in advance.
  12. A

    jumpers electrical ground or what?

    ok is it electrical ground or dielectic. I will remove then replace when done, should I shut off electrical breakers or is it necessary? Should I place it in a different spot or can I remove it for 3 hours or so then replace?
  13. P

    New unvented system - ground floor losing pressure

    Hi there, wondering if anyone has any pointers, in the middle of a stressful refurbishment that was meant to finish a week ago! I am completely in the dark about boilers, but we agreed to the recommendation of a new pressurised unvented system that would feed direct off the mains (Vaillant...
  14. R

    Ufh in timber ground floor

    Hi all I'm building a single story rear extension and would like to use UFH It's going to be a timber joist for with 22mm chipboard flooring running from a combination boiler What is the most effective way of installing the UFH? 1) spreader plates. 2) celotex between joist with a biscuit mix...
  15. H

    What is a black pipe BS1972 we have found 4 inches below ground in our garden?

    Hi, Please could someone provide any advice on what a black pipe with Tenaplas Ltd BS1972 on it, could be? Do you think it is a water pipe, rather than any other utilities? (e.g. telephone, electricity, etc...) We have found it 4in below our garden (we haven't unearthed all of it yet), so don't...
  16. C

    Upstairs Toilet Draining into ground floor soil stack.

    I'm looking to connect an upstairs toilet into an existing ground floor soil stack. Is the solution I've drawn out possible or does the soil stack vent need to be above the connecting appliance still? Red is the proposed new pipework and brown the existing. Let me know any questions.
  17. A

    Hot water heater for ground floor extention?

    Hi guys, looking at a ground floor extention for the customers elderly mother. She's going to have her own bathroom and kitchen and I need a hot water source for this. Existing house is a gravity fed system which already has an aqualisa visage pumped shower installed and the mother wants one...
  18. A

    Can a gas boiler flu run externally from ground to second floor?

    does anyone know of a system that will allow a gas boiler (any) with a flu length to reach the ridge line (second story from ground) on the outside of the house, so about 7 or 8m? The boiler can be mounted on the external wall so there is only one bend. We have an annoying neighbour and so...
  19. T

    Intermittent heating from rads on ground floor - no issues with 1st floor

    Hope it's permissible to request some input here... I live in a rented flat in London. We have two floors, ground and 1st, with radiator heating. The boiler is working fine (I believe) and we have plenty of hot water (radiator temp set at and hold at 73C). Four rads on the 1st floor are merrily...
  20. M

    Rads still cold on ground floor in 3 storey house.

    Hi Maybe someone can advise on this scenario: Property: 3 storey semi-detached townhouse, built c.2004. Hot water: Megaflow system, in upstairs airing cupboard, which works well. Heating plumbing: 10mm plastic microbore, header tank in the loft. Boiler: Natural gas IDEAL Logic 18Kw+ (upgraded...
Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock