Discuss Help identifying a toilet cistern filler valve? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
A
Aire
Its a fluidmaster, most plumbers merchants will sell them or you can get them from screwfix.
- Messages
- 8,642
Buy one with a brass tail , there still plenty of the plastic ones available
B
Burger
What’s the reason for renewing the valve? Diaphragm should are available if it’s a noise/not shutting off issue.
Steve weightman
Gas Engineer
- Messages
- 186
It's the older type of fluidmaster I'm one for repairing but for the sake of £8+ I'd replace it
Reply to Help identifying a toilet cistern filler valve? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Hi all
Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Hi,
My current hot water system needs to be replaced.
Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off?
An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au.
How reliable is this...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
-
-
-
-
Mixer mixer shower, compatible with tanked supply
- Started by Matt0029
- Replies: 2
-
-
No Hot water, Fixed and Broken Again Ideal Logic 24
- Started by Filthbags
- Replies: 2
-
-
What's happening to this radiator, paint flaking off?
- Started by mikmikmikmik2024
- Replies: 3
-
Is it necessary to earth bond a Kitchen Sink?
- Started by Cello
- Replies: 5
-
Show us your fanciest radiators you have installed!!
- Started by Lou
- Replies: 1
-
Y Plan, no hot water but heating is working when called
- Started by Chopper9495
- Replies: 8
-
-
Towel Rail Valve Advice please (35 Characters needed.)
- Started by NorthernLad
- Replies: 7
-
Unvented discharge at high level current regs
- Started by Matt0029
- Replies: 11
