Search the forum,

Discuss Strange Water Inlet Valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
5
Hi all,

Our boiler water pressure has dropped and I need to refill to get it to work again but the valve on the water inlet pipe is very odd and I can't find a tool or key to turn it.

Does anyone recognize this and know what and where I can get a key?

Any help, much appreciated.
valve.jpg


Rob
 
Hex key will fit but will not fill your boiler.
You have been watching the wrong YouTube that was a combi.
You will have a external filling loop as others have stated.
Have you got an F22 ?
If so what you going to top it back up to?
 
Airing cupboard silver valve
 
That's it, they both go on untill it's between 1/1.5 bar then BOTH off again.
If the pressure dropped on its own then you've got another fault but topping up will get it running for now
 
Thanks for the advice all.

I was surprised to learn that those two taps were the filling loop. As you suggested, opening those has brought the pressure back up to normal range.

Much much appreciated we can have a hot shower again..

I will be getting someone out to do a service especially if they spot anything causing it to drop but I appreciate the help from everyone to get us up and working again.

Thanks

Rob
 
Thanks for the advice all.

I was surprised to learn that those two taps were the filling loop. As you suggested, opening those has brought the pressure back up to normal range.

Much much appreciated we can have a hot shower again..

I will be getting someone out to do a service especially if they spot anything causing it to drop but I appreciate the help from everyone to get us up and working again.

Thanks

Rob
Take a quick look around your rads and pipework. See if there are any weeps or drips.
 

Reply to Strange Water Inlet Valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I have a very strange issue with my BAXI 105e DHW. if i turn on the hot tap the pump starts and demand for DHW is shown, after a some seconds it will show an error, 60 degree, pump or flow. Well switch the tap off wait maybe fifteen seconds turn tap on and low and behold hot water. If after a...
Replies
1
Views
477
Hope someone can offer some help with this issue, I have a Baxi 105e works fine no real downside, serviced looked after regularly. Have an issue with hot water, open hot water taps runs cold and indicates on boiler 60degrees or pump or pressure problem. Leave it ten seconds open taps again low...
Replies
3
Views
489
Hi, I need to drain my vokera 29 boiler in the attic as Im going away for 4 weeks at least to make sure there are no frozen pipes. In my small 3rd floor flat, I have a radiator in the front room and one in the hall (very close to each other), there is a drainage valve on one of these. My back...
Replies
1
Views
253
Hi all, Got a strange grating noise when the mains water is running in a property I'm looking after. It's a ground floor flat, with a first floor flat above it, and both share the same mains water pipe, and I believe the stopcock behind the washing machine isolates all water to both properties...
Replies
2
Views
496
Hi,

 Our heating stopped working today. We've got a Veissmann boiler that's under a year old, and an older Megaflow cylinder, and two diverter valves (all about 10 years old). We also use a Hive thermostat.

 When I boost the hot water with Hive, the receiver near the boiler shows it's...
Replies
1
Views
648
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock