hi everyone,
I’ve just changed my circulation pump and I only noticed before re-fitting that the diverting valve was set on HW.
So I must’ve drained the HW side to just below pump level?
Then I refilled and turned it on.
Is there any way I must bleed it now as it’s the HW side?
Sorry if...
hi,
Well that’s the new pump and gate valves in.
These are the valves
Pegler Pump Valves 22mm x 1½
Should they just be turned 90 deg?
Or open them until they stop?
Many thanks!
hi,
Just about to fit my welo replacement pump and realised the head and base have conflicting arrows?
What one is correct?
It’s not a new erp, it’s and old style If makes any difference.
Appreciate any help, thanks!
apologies but can you explain a bit more about the differences in power/flow rate, if you have time?
I'm guessing it has something to do with erp/non-erp eu compliance?
It's just my existing pump has 3 speeds, it was set on the highest:
0.45A - 104W - 1850 n(min-1)
Which seems a lot higher...
Existing one looks very similar to this but with different power/rate.
If I hang off until tomorrow I can get this one which seems right.
But could I use something like this?
Thanks again everyone,
...away to check voltage, capacitor, arrow and take picture.
Hi @steadyon thanks for your quick reply.
Will give the capacitor a check. As the pump case heats more than the water but the motor hasn't seized. And get the burnt electrical smell.
Although, It won't even try to spin when helped along which put me off the capacitor and the pump is pretty...
Hi everyone,
Well...with my luck, my circulating pump has crapped out leaving us freezing!
Id really appreciate some help choosing a replacement.
I have a 2 bed flat with electric Trianco boiler and closed Y plan system.
Ive bled the system and while spinning the shaft/bleed screw the motor...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.