Search the forum,

Recent content by markfxy

  1. M

    CV help

    That's great Dan much appreciated I'll do a rough CV over the weekend any PM you thanks againšŸ‘
  2. M

    CV help

    Cheers I'll have a read through that
  3. M

    CV help

    I need to do a CV but as I've been self employe for over 30 years I haven't got a clue how to go about it! how far do I go back how can I list all of the jobs I've done I've forgotten most of them. any help would be appreciatedšŸ™‚
  4. M

    Supper Insulation ??

    that stuff is a bugger to drill through it wraps round your drill bit and you can't get the dam thing:confused: out it is very efficient though
  5. M

    Here we go again with gas

    fecking gas boilers I can't wait till we start using coal again;)
  6. M

    Ufh problems temp control and radiators temp

    cant you turn the boiler temp up and turn the flow rate down to lower the temperature to each circuit
  7. M

    Unvented confusions. Help a brother out.

    Does the tap have a softflow filter check if that's blocked
  8. M

    Wet room tray result!

    yes I meant former
  9. M

    Wet room tray result!

    Yes tiled, I've use their trays where you tile over the waste cover they're absolute pants you have to try and click together the trap rather than a screw thread, the ones with standard stainless grates are pretty good
  10. M

    Wet room tray result!

    I know, I've paid more than that for a trap on some trays!
  11. M

    Wet room tray result!

    Just doing a small wetroom I phoned my local supplier for a quote who said they don't sell many as such they're not very competetive quoted me Ā£450.00 for an 80x80:eek:, I went online to check the underfloor heating store price Ā£62.99 including trap for a prowarm tray! Makes a nice change to...
  12. M

    How Long To Retain An Estimate?

    Can you find it on an Email? or did you post it
  13. M

    Oso unvented. Cold water through tundish

    I had one recently the prv was running intermitently turns out it was the basin mixer tap the mains pressure was lifting the ceramic disc and pressurising the cylinder I put an nrv on the hot feed to the tap and problem solved. Took me a while to sus it out though:confused:
  14. M

    UFH Joist system and Manifold selection - Evohome

    You would need to batten the joists then ply on top then kingspan I can't see the weight being a problem if the joist have short spans, We use 30mm pug screed and usually leave it a week before covering it's quite dry so you could get away with less time. Aluminum plates are an absolute ballache...
  15. M

    Nightmare Plumber Who lives Across The Road

    Just sounds like your average plumber to me;)
Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock