We are currently looking at the possibility of purchasing a new build terraced property. The outside tap is located at the back of the property.
How easy would it be to install a outside tap at the front of the property? Ideally it would need to have its own valve inside so knowbody else could...
Thanks for the advice. Both the boiler and cylinder were serviced last October. I will attempt to replenish the air gap and see if this resolves the banging issues. In relation to the boiler issue, is there any user maintenance I can try for this or do I need to get an engineer out? Thanks.
Hi all,
Any help with this one would be much appreciated as I have no knowledge of plumbing.
I have a Potterton boiler and a Megaflo cylinder system. I have noticed that when the boiler fires up to heat the water that sometimes at the end of the cycle the boiler pressure drops on the gauge and...
Hi all,
I would really appreciate some help and advice with the following issue.
The basins in both my bathroom and en suite have started to back up. I have very little knowledge of plumbing but I presume as they the basin are back- to-back they will both be connected onto the same pipework...
Hi,
I have recently had my Megaflo Unvented Cylinder serviced but didn’t check if the plumbing and heating engineer was G3 qualified before they carried out the work. I understand that it is a legal requirement to be G3 qualified to install an unvented system but is this also true to be able...
Thanks for your help both. I don’t think I held the value open for long enough, I found finding the correct position to keep the value open difficult, it kept clicking closed again. It looks like I have carried out the process correctly but just need to keep the value open longer until the...
Thanks Chris. So just this one in the picture then?
1567859226
I have given it a go. Not sure if I fully completed the process correctly though but made sure that all hot water had stopped flowing from the downstairs open hot water tap before turning the cold water valve back on by the cylinder...
I have noticed water dropping intro the tundish of my Megaflo Unvented cylinder. I believe I need to replenish the air gap.
Do I need to switch both the levers/valves off in the pictures attached before starting the process?
Thanks in advance.
I have a Roca bathroom mixer tap, when hot water drains through the trap there is a high pitch tapping noise which sounds like it’s coming from within the mixer or trap itself.
It’s not a knocking noise like the pipe rubbing on stud wall as it’s very a high pitch noise. Sometimes it can be...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.