Search the forum,

Kirstymarmite

  • Thread starter Kirstymarmite
  • Start date
  • Replies 11
  • Views 1K

Discuss Kirstymarmite in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
K

Kirstymarmite

Hi all.
 
Hello
 
Hello, you are now the record holder for the shortest initial post on record.
 
Welcome to the forum's Kirstymarmite......regards Turnpin:welcome:
 
Hi ( my preferred breakfast = on hot buttered toast ) Enjoy !



( sadly concise - just aids confusion )
 
Status
Not open for further replies.

Reply to Kirstymarmite in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
463
Chuck
C
F
Mystery Mira Elite QT Leak
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
222
Firefox
F
P
LCS to new water mains
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
185
ShaunCorbs
ShaunCorbs
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
227
exedon2
exedon2
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
179
ShaunCorbs
ShaunCorbs
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock