Search the forum,
Questions and plumbing advice in the Renewables - .

Some popular plumbing forums: Plumbing Advice - Plumbing Tools - Plumbing Courses & NVQ's

Forum Prefix Filter

  • Sticky
Has anyone had a good look through this Strategy to lower Carbon emissions by 2050? Introduction from the govt website The heat and buildings strategy sets out the government’s plan to significantly cut carbon emissions from the UK’s 30 million homes and workplaces in a simple, low-cost and...
Replies
5
Views
1K
Is anyone interested in a two butt rain/bathwater/greywater recycling project?
Replies
2
Views
267
    • Like
Morning, Does anybody know what happens to a solar thermal flat panels (a pair on south facing slate roof) that have been unused for at least 12 months possibly year before also. System has been switched of due to loss of pressure. How will last years heat wave conditions have effected the panel...
Replies
2
Views
382
J
Hi Can somebody tell me if a standard heat source pump installation uses a pressurized hot water tank? Or will the pressure for the hot water be the same as with my oil boiler and water storage tank (gravity-fed)?
Replies
1
Views
428
B
We are installing solar power irrigation systems for smallholding farmers in Rural Ghana, We have 12V DC 0.18kW (max 20A) pumps, there only power source will be a voltage varying from 15-20V coming from solar panels. The boreholes are narrow, therefore is not much room for a float switch...
Replies
0
Views
461
barnaby_david_king
B
Hello All, newbie here. I am building a new home on a spacious plot and considering a ground source heat pump instead of air source. I understand trenches need to be 1.2m deep, 1m wide, and 5m apart. But how level does the overall site have to be? My site is on the side of a hill and the...
Replies
1
Views
506
Hello My solar thermal system appears to be leaking fluid (pics attached). Could anyone give me an indication of what the issue is likely to be and the potential cost to rectify? The system was installed in May 2021 and has a flat plate panel on the roof. It works very well generally and...
Replies
1
Views
552
We are installing solar power irrigation systems for smallholding farmers in Rural Ghana, We have 12V DC 0.18kW (max 20A) pumps, there only power source will be a voltage varying from 15-20V coming from solar panels. The boreholes are narrow, therefore is not much room for a float switch, The...
Replies
2
Views
598
Hi. Hopefully someone can point me in the right direction. Bit general. We have solar boosting our hot water using iboost. My question, the current immersion element hasn’t been changed for 14 years. Should I upgrade/change it to increase efficiency? Current I haven’t seen any degradation in...
Replies
6
Views
626
J
I'm building a new house and I have no idea what option to chose for heating/hot water! I've looked at biomass/pellet boilers, electric combi boilers, air source heat pumps and solar panels(combined with an electric boiler) After doing a lot of research (and not understanding some of the...
Replies
1
Views
698
  • Question
Hi all Are there any Windhager Biowin2 experts who can help me to understand what this means? I’m fairly sure mine doesn’t have such a mixing valve and not sure what or why one is required. I’d like to understand before trying to find someone to install what the original installers omitted 8...
Replies
0
Views
762
K
Has anyone installed / worked with air-to-air heat pumps? I wonder if their running cost is also high? There’s no information on running cost and even the people handling the funding pots for Air source heat pumps, are not aware of the costing.
Replies
0
Views
768
Katelina
K
What are the factors that determine the life of a water tank? Obviously the quality of the water and the materials used to construct the tank are important. But beyond that I'm fuzzy. Is it just the number of gallons of water that pass through it? The number of "fresh" gallons of water that...
Replies
1
Views
832
J
  • Question
Hi all, my parents have had an air source heat pump installed a couple of years ago and have recently started undergoing refurbishing the house and have had several radiators removed and repositioned, can anyone help with regards to how to top up the system as I know that it has to have a glycol...
Replies
1
Views
901
Hi, Solar thermal not so big these days but a couple of Q for anyone who still works in it. Background. I'm an Electrician not a plumber.. I've been maintaining my otherwise excellent solar thermal (Original install MCS by Others), for the last ~ 18 years, over which time I've needed to clean...
Replies
2
Views
906
Helping to audit an electric-only house with ASHps -NIBE kit installed into the new house in 2012. 2 ASHPs outside -each F2015. I put on some monitoring of their electrical usage -each takes 40W night and day 24/7. It's August so they are off 99% of the time: but when off, still use 40W...
Replies
7
Views
912
I have a head height problem for the storage tank and needed a solution that would allow the monobloc to heat from the bottom of the tank I have now sorted the issue with 2 tanks in series, both single coil The smaller one has solar heating and this then provides cold, warm or hot water to the...
Replies
7
Views
951
    • Funny
    • Like
Calling all plumbing and heating engineers. We are doubling our heatpump installation team across the UK and need plumbers and heating engineers to help decarbonise the UK. You can apply directly on the Octopus website, or you can contact me directly.
Replies
3
Views
1K
C
Hello, I hope somebody may be able to help. I have a ecodan heat pump system and have no hot water. The controls are set correct but the light for the boiler is blue. Anyone know what I’m going wrong please? Thank you!!
Replies
1
Views
1K
Deleted member 120897
D
Hi all. I have an Isoflo CL170 cylinder with good few years life left in it in my system which has performed trouble-free other than the odd new immersion element. I'm getting a new ASHP fitted and the installer is recommending scrapping the Isoflo and replacing it with a Secon Trade Heatpump...
Replies
3
Views
1K
S
Just wondering if anyone has even seen an issue with the pressure gradually increasing on a closed loop system where there is no fill loop attached. I'm seeing this issue on a gshp and whats more unusual is its on the cooling side. If it was on the heating side you could put it down to expansion...
Replies
5
Views
1K
Post a New Thread / Question
Creating content since 2001. Untold Media.
OFFICIAL SPONSORS

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock