Hello everyone, so I've decided to embark on my journey to becoming a qualified plumber. However, i am unsure if these training courses and providers are legit. My brother had an experience a few years ago that turned to be a scam. The company name is 24/7 Training UK. Weekly payments of 45 quid...
We have a Triton T80 shower. When anyone runs more water in the house - such as flush WC - the temperature in the shower shoots up and is extremly hot - compared to the setting. There must be a temperature sensor/thermostat that controls temperature. This is obiously faulty. So when pressure...
Hi folks, I’ve (until now, successfully...) done all the first fix plumbing on my newly configured bathroom in my flat only to notice that I’ve somehow put a tiny hole (maybe 3 or 4mm wide) in the flexible toilet waste pipe I installed. The floor is now tiled (underfloor heating, cement board...
Afternoon Ladies & Gents, I am having a repeat problem with my Grandma's Immersion Heater Thermostat. The thermostat is a 18" Tesla Dual safety variety from Screwfix. Grandma had a new cylinder and header tank fitted with immersion heater, no other source of hot water. I have replaced the...
I'm a DIY homeowner repacing an outside toilet pan to a salt glazed spigot in a concrete floor. My guess is to cut through the mortar surrounding the spigot and continue cutting through the spigot. What are the pitfalls and tips to assure a clean cut through the spigot. Further will a plastic...
Hello, I would like to know going by my image supplied if that black valve is open or closed? I would also like to move it so I can dangle the power cable so it doesn't touch anywhere near that hot pipe.
Is it normally left in this position?
1582538148
As you will see I have it pushed out...
Hi guys,
A layman here. Have got this gas heater/boiler at home and it stopped heating hot water. The real estate is getting a new boiler but I'd like to ask anyway. I was told that if I hold the reset button for about 10 second I should have a hot water regardless if it works but the tap must...
Hello everybody, my names Toby I’m 25 from Essex and I’m looking to pursue a career in plumbing/gas installation etc. I’m currently signed on for a C&G 6035 level 2 diploma starting in Feb lasting 6 months. I’m trying to find a way into the plumbing industry as after wasting the earlier years of...
Hi all
Ive jjust had a new Baxi 836 installed.The engineer couldnt line up the flue from the top of the boiler to existing hole.He,s offset the flue at an angle to go thru said hole and placed sealing ring on the flue but it doesn,t cover existing hole,there,s an inch gap one side.Would this be...
Hello,
Popping by to say hello. I'm slowly renovating a house, learning all sorts as I go. I did a short DIYers plumbing course and am ready to get stuck in with fitting new radiators in the first two rooms we're completing🤞
Cheers,
Laura
I am looking to replace my current toilet with a back to wall one, one issue that i have is that the soil pipe would end up being under it. Would it be a bad idea to fit a Slinky-Fit Flexible Pan Connector from the toilet into the soil pipe that is directly under the toilet?
Hi having a repeating fault 1st its has presser hot water and heating work
Well last night it stayed on even after program had turned off set for 2130hrs was still on at 0230 when i hot up but it would not turn off tryed reset but came back on ended up turninging off electric to boilor .to try...
Hi All,
Thought I would drop a quick intro as I have just joined the forum ( after a few months lurking). I'm currently half way through my Gas course, having decided on a career change a bit later in life than most, and have been enjoying the challenge so far. I have been reading as much as I...
Hello there. I've tried posting a question on the general plumbing forum yesterday but it's still awaiting approval. Is that normal? There wasn't anything controversial in it!
I live in a flat with very low mains water pressure, worst since lockdown for some reason though was told the water board had lowered rather then have a hose pipe ban.
The problem is a slow filling tank after a power shower. I have put a regulator on the shower head to slow flow.
Is it possible...
Hi all!
New to all this and currently training to do my ACS for a change of career! (Had to grow up and stop playing with motorbikes)
I found this website while looking for information to write up some method statements but while I'm here, if there are any Gas Safe engineers in or around north...
Hi everyone. Hope your having a nice day.
I was wondering if anyone could help with the following ?
The existing hot and cold water pipe that leads to the bathroom on the first floor needs to be covered in the kitchen. I was proposing to do this with a plastic double pipe cover. The problem is...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.