Search the forum,
Questions and plumbing advice in the Central Heating Forum - Also see on the electrical forum: Central Heating Systems..

Some popular plumbing forums: Plumbing Advice - Plumbing Tools - Plumbing Courses & NVQ's

Forum Prefix Filter

Got a vaillant ecotec boiler and it makes an awful noise sometimes which stops when the hot water tap is turned on, boiler is fully serviced and clean, couldn’t get it to replicate for the last service so the engineer couldn’t find anything wrong!
Replies
7
Views
7K
No really researched this yet but can anyone tell me if there is a heat only boiler on the market that does a side exit flue ? We get quite alot of old boilers that we have relocate because the new top or rear flue type just wont be possible. Normally if replacing a boiler in a kitchen cupboard...
Replies
3
Views
7K
How does a boiler sense the condensate pipe is blocked?. Boiler stopped working. I was told the condensate syphon was blocked and had to be cleared. I wondered how the boiler controls knew this?
Replies
12
Views
7K
I have a rather large wet UFH system. Water is flowing around the system, but I don't get any (or minimal) hot water injecting from the primary boiler flow into the ufh system. this means the mix temp never gets above 20 degrees. I think that the ufh system's pressure might be too high which is...
Replies
52
Views
7K
Some vented heating systems seem to sludge up, and yet other remain remain remarkably clean after many years service. Why? Corrosion is caused by oxygen. Eliminating leaks and inhibitor helps, but the F&E tank is open to the air, so oxygen can freely get in there. Is it possible to design a...
Replies
48
Views
7K
J
  • Question
Hi - this is driving me nuts and I can’t figure it out so any thoughts welcome. The hive receiver at the boiler is correctly receiving a signal from the thermostat to turn the heating on - but then… nothing! This definitely isn’t a hive communication issue given (a) the hot water via hives...
Replies
3
Views
7K
Deleted member 120897
D
Doing some decorating I discovered that some of the central heating pipe work is grey plastic. System installed 20 years ago by previous owners. My question is was that normal practice back then and is it likely to cause any problems in future? All exposed pipe work to rads is copper.
Replies
7
Views
7K
    • Informative
Let me preface - I install and repair boilers and in my humble opinion Worcester Greenstar i aka Junior isn't a good boiler. I realise why they are very pupular - the Bosch name, the marketing (best friends with Which?), "trusted" by the big installers. Installation - Probably the hardest...
Replies
14
Views
7K
  • Question
Evening Hopefully you're not sick of this type of question! I've had a few quotes for a boiler upgrade (going from a regular boiler (~15 yrs old, on its last legs) to a combi) - all recommending different brand/model of boiler, and all company's are saying that their recommendation is the best...
Replies
11
Views
7K
Deleted member 131795
D
Hi all, I just joined the forum as I couldn't find help just being a lurker. :) I just bought my first house (yay me) and it's a new one. The installation has been done my a bunch of different people and the plumber himself couldn't explain fully what he's done (yes, you read it right). I...
Replies
35
Views
7K
Hi all, The burner keeps locking out on my boiler with increasing frequency to the point it can be every few minutes. So I thought it was locking out when working but it's seems it gets up to temperature shuts off and this can happen the first time or any number of times. Quiet buzzing Louder...
Replies
15
Views
7K
Could someone confirm if the Potterton EP2 programmer is a DIRECT replacement for the EP2002? In other words the one programmer is unclipped and the other is clipped on without any rewiring? I have read differing reviews that indicate if my EP2002 acts as a wiring centre it is not quite as...
Replies
4
Views
7K
The central heating on my Baxi DuoTec Combi 28 HE A has stopped working but the hot water is fine. I have also discovered a leak from somewhere on the lower isolation valve to the Fernox TF1 Compact filter, it may just need tightening up. I'm guessing that it could be the diverter valve but...
Replies
7
Views
7K
I hope someone may bring some quiet to our home. Our plumber recently exchanged our aged Honeywell analogue thermostat for a DT90E. Hurrah we thought, we know what the temperature actually is, and we can set the heating accurately. All settings are factory. Heating is on. Set temperature is...
Replies
11
Views
7K
Hi boiler in question is a Viessmann 100-W WB1B Heat Only Boiler with F&E Tank in loft etc and Cylinder appreciate some advice please Not sure if connected but Engineer just been and serviced boiler etc 1 day ago and, by mistake he seems to have left it in Service Mode so when the hot water was...
Replies
2
Views
7K
If the bath top shower is used by turning on the cold tap first, then the hot supply, it will give a consistent short shower, but that is getting shorter day by day before it goes cold. If the hot is turned on first, then the cold, that will result in domestic supply going cold within a few...
Replies
5
Views
7K
I'm thinking about going self employed after working as Service and Repair engineer at BG for 10 years. Advice please!
Replies
23
Views
6K
Tried repressurising by turning valve on filling loop. Normally you hear water whoosh through. This time no water. Took lever off and turned with spanner then took loop off and tried again. Water is coming through so now thinking broken NRV, is there a way to fix them or could it be an issue...
Replies
13
Views
6K
Rotten Cabbage Smell coming from boiler . This is the first time I’ve signed up or posted anything like this in my life time to a forum but I am at my wits end. So...... Rotten egg cabbage smell coming from boiler in December 2019. Thought it was gas called out cadent they got a small reading...
Replies
10
Views
6K
Have noticed over the last view days the process has slowed considerably. Normally, the boiler fires up soon after the room stat clicks in and it gets up to desired temp within a few minutes. Have noticed the boiler is much quieter when it does ignite (approx 10 mins after being switched on) and...
Replies
13
Views
6K
Post a New Thread / Question
Creating content since 2001. Untold Media.
OFFICIAL SPONSORS

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock